Probably nothing initially for a few times, but if you repeatedly do this, you may eventually wear out the spring that activates the firing pin or have the firing pin release too far out. There are devices called "snap caps" that fit into the chamber of the barrel and allow you to pull the trigger and release the firing pin into a small spring loaded portion of the snap cap. This is the best way to store your shotgun, with a snap cap in place and the trigger pulled releasing the firing pin into it.
The hammer will be in the cocked position. Nothing will happen until you pull the trigger.
Pull the trigger
First, clear the shotgun and make sure it is completely unloaded. Open the action halfway and unscrew the takedown screw. Pull the barrel forward and remove. Push the trigger housing pin out of the shotgun and pull down the rear trigger guard. Remove the cartridge stop and cartridge interrupter. Pull the bolt slide out of the bottom of the receiver. Push the forearm grip forward and off the gun. Push the bolt out of the hole where the barrel was. Move the elevator out of the bottom of the receiver and you are finished.
go to launch shotgun and grab the shotgun and pull it back and pull it forward then press the trigger
The only way is to replace the whole trigger but it will still have a hair trigger
Depends on the how the requirments were written for the purchase.
When a gun fires more than 1 shot per pull of the trigger. In most cases, pull the trigger. Gun fires, ejects fired cartridge, loads fresh cartridge, fires it, and repeats until you release the trigger or run out of ammunition.
When you pull the trigger the hammer (which was cocked back before) is released and it hits the primer on the cartridge which sets off the powder in the cartridge, and the bullet is propelled forward.
Depends on the agency, lawyers, manufacturers and insurance companies.
Whichever one you pull the trigger to.
Yes and no. The Glock does not have an external safety that is operated by the shooter. The safety mechanisms are controlled by the trigger, and function when the trigger is pulled. If the trigger is NOT pulled, the safety mechanisms prevent the firing pin from moving forward and striking the cartridge. However, if a Glock has a cartridge chambered, AND you pull the trigger, the gun WILL fire.
First you have to find the right sized bb's for it and then load it into the cartridge and then cock it... point... and pull the trigger