the capital letter "H" refers to the hole and lower case "h" refers to the shaft.. and the number "7" Refers to the tolerance grade , and 50 is the basic size of the hole(H) and shaft(h) respectively..
regards,
PRASAD BG
no differnece
the addendum is the top most dia in the component where as the dedendum is the least dia
In Full bore ball valve, The bore dia will be same as internal dia of the pipe.In reduced bore, the bore dia is reduced than the ID of pipe.
one inch is one inch; one inch dia refers to one inch diameter of a circle; it is still one inch
when height & Dia ratio is less than 1 that is tank otherwise silo
i think the only difference is hole dia of injectors. which also results into difference in operating pressure and through flow.Further combustion process varies accordingly.
The first phrase is "What day is today", the second is "what date is today".
A typical flight between LAX and DIA would have a flying time of about 1 hours, 43 minutes.
Is 100/56 bad bp?what is good differentiate between sys. and dia.
in 4 core cable all four cables are equal dia and in a 3.5 core cable 3 cores are equal dia and fourth one will be with half dia. and it is used for neutral in 3phase 4 wire syastem
Diamagnetic materials are weakly repelled by magnetic fields, while paramagnetic materials are weakly attracted to magnetic fields.
The equatorial diameter of the Earth is about 12,742 km, while the polar diameter is about 12,714 km. This means that the Earth is slightly flattened at the poles and bulging at the equator, resulting in a difference of approximately 28 km between the two measurements.