Answer from Choices (http://www.choicesflooring.com.au/vinyl/) Generally, cushion vinyl is laid loosely so any imperfections in the floor don't show through over time. It can also be glued down, but the flooring needs to be completely level. Vinyl tiles or planks are glued down so the surface needs to be completely level, which is done by applying a self- leveler to the floor if required.
Grano Screed is a type of flooring. The flooring is a tile-type of flooring. You need to use cement to put the flooring down.
If the tiles are down tight and the added height wont bother you, it is fine to go over the tile with carpet glued down or over pad. The installers will hate setting the tackstrip, but it is part of the job.. you are good to go.
No. Carpet that is to be glued down must have a clean, smooth and sound surface prior to installation. It is necessary to remove the existing carpet before installing the new. Scrape away any old adhesives best as possible, vacuum, use a premimum adhesive or contact adhesive, and press the new carpet into the adhesive to get a good transfer.
NEVER, The heat will break down the finishes over time. The same is true with vinyl flooring, hardwood, laminate, LVT and grouting. Steam is meant for carpet only!
You can either remove your flooring or you have to buy it, but you can only buy it if you are a member
The best contact adhesive to use to stick down flooring is cork flooring. Cork flooring has a very high rating, and is the most effective and cost-effective way to stick down flooring, according to a lot of reviews.
There is no specific hardwood flooring glue as it's not supposed to be glued down. You could glue it with a good quality wood glue, but most manufacturers warn that this can cause buckling later on. It's generally angle nailed.
Answer from Choices (http://www.choicesflooring.com.au/vinyl/) Generally, cushion vinyl is laid loosely so any imperfections in the floor don't show through over time. It can also be glued down, but the flooring needs to be completely level. Vinyl tiles or planks are glued down so the surface needs to be completely level, which is done by applying a self- leveler to the floor if required.
Yes. Apply pressure against it until the glue sets. For the floor just glue it down.
Not the best idea. Hardwood floor should be angle nailed down, but obviously you cant do that. I think hardwood flooring would dry out and separate in places if glued.
Yes, they sit on top of the flooring. You may be able to pull them out from under the base, but that will be hard if they are nailed down close to the wall.
It depends on the type of floor that you are putting down the vinyl flooring on top of. If it is concrete, then make sure it is clean, dry and repair any cracks or holes. If the old vinyl flooring is in good repair then just put the new vinyl flooring over it or use an embossing leveler for slightly worn vinyl flooring. If the old vinyl flooring is in very poor shape remove it completely. Plywood underlayment can be used for other types of flooring that you will put new vinyl flooring down on top of.
click the fk in glued the fk down nailed the fk on stapler from the primary school sticky tape and duct tape pvc glue that muddafkr blutack does the job
It depends on what you are gluing it to (concrete, plywood, tile). Research the different adhesives available from your flooring dealer.
Sand down the layers that are scratched with a sander, which you can possibly find at your local hardware store.
The engineered flooring can be either floated above or glued to the concrete.