i wld like to put lightson my motorbike but lights r 240v and bike is 9v how do i do it
Yes, for about .1 second, then it will blow the lamp. A 9v battery will however light three 3.5v lamps.
When our 93 grand prix battery light came on it meant that we needed a new battery. We tested the battery with a volt meter and the battery read 1 volt, it should be 12volts. Still wondering how to reset the battery light?
first you need a led light (like on Christmas lites), a 3 volt battery, tape and a magnet first slide the battery in between the wires on the led light the long wire should be on the positive side of the battery. then put tape around the light and battery. Finally put the magnet on the positive side of the battery.
Unless the switch has a pilot light on it there is need for a neutral connection to the switch.
Some have a switch for 6 or 12V - if not you will "cook" a 6 volt battery using a 12 Volt charger
Yes, if you have a 12 volt battery and/or a charging system to support it.
Dead or weak battery? Alternator not charging battery properly?
Connect a 12 volt battery charger to the battery.
If it is a 1.5 volt bulb you can connect it through a series circuit directly to your battery. If the bulb is not made to run on 1.5 volts and needs another voltage, it may not light up!
Yes it it is a 12 volt DC light bulb. It will not operate a household 120 volt light bulb.
The 1964 VW Beetle came from the factory with a 6 volt electrical system. Unless it has been upgraded to a 12 volt system you would need a 6 volt battery. I would recommend you check the voltage of the current battery with a volt meter. If there is no battery in the vehicle, just remove a light bulb and check the voltage written on the bulb.
It depend on what the rating voltage of the LEDs are.