answersLogoWhite

0


Best Answer

I'm new to wiki, so don't really know where to start. I bought a 134A guage set on the bay but when it arrived I couldn't figure out how feed the gas into the system. Connected the blue and red hoses but the yellow feed hose would not fit the tap on piercing valve. Is there some kind of fitting adapter? Thanks, Mike

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you use the r134 a manifold gauges the yellow hose will not fit the can piercing valve set?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why are Pressure gauges fitted outboard of the manifold valve on Tankers?

Because the manifolds has blanks plates bolted on them when not in use, and if you take off a blank you will want to know if any pressure has built up behind them from a leaking valve. You also want to know if it is safe to disconnect a cargo hose from the shore terminal after you have closed the manifold valve.


How does a 2 way manifold valve work?

by your


How does a 5 valve manifold work?

blah


How do you know when a manifold tuning valve is bad?

You can tell when a manifold tuning valve is bad when oil is leaking through it. You also can tell by inserting the dipstick into the valve and seeing if oil comes out through the dipstick.


Where is PC valve on 93 Geo Metro?

do you mean the PCV valve? the PCV valve is located in the intake manifold


How do you bleed the manifold on a 1990 Buick LaSabre?

There is air in my manifold and can't find the bleeder valve to release it so how do i bleed my manifold?


What type of measuring tool is used to check valve clearance?

Feeler gauges.


Where are the EGR valve PCV valve and oxygen sensor on a 1993 Mitsubishi Montero RS 3.0 liter engine?

The PCV valve should be under the intake manifold- pretty tough to get to w/o actually taking off the manifold. The EGR valve should be on the intake manifold itself. The O2 sensor should be threaded into the exhaust manifold(id by wire attached to it). Good Luck;)


What to do with Oil leaks by manifold?

If you are talking about the EXHAUST manifold then most of the time it's the valve cover gasket that is leaking oil. REPLACE VALVE COVER GASKETS. If you are talking about the intake manifold then it has 2 rubber gaskets in the front and rear of it that leak oil real bad. If oil is on the left are right top sides of the intake manifold were the valve covers are then it will be the valve cover gaskets that are leaking oil.


What is Manifold valve?

lawn spirinkler/irrigation system


Where is PCV valve located on 1992 mustang?

The PCV valve is located in the back of the lower intake manifold. It should have a 3/8" hose going from the PCV valve to a vacuum source on the upper intake manifold.


Does a 1994 dodge ram 1500 have an egr valve?

Yes, back of intake manifold.Yes, back of intake manifold.