answersLogoWhite

0


Best Answer

On the left side of the safety switch there is a pin that blends into the pistol pretty well. take that pin out and the gun should come apart.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take a colt delta elite 10mm apart to clean?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Price for new colt delta elite custom combat?

Colt Combat Elite (45ACP) $1000.00 Colt Delta Elite (10mm) $1000.00 (not out yet)


How much is a colt delta elite 10mm worth?

100-1000 uSD


How much is a colt delta elite 10mm gov model de17520?

50-700 usd


How much is a Colt Delta Elite 10mm Auto pistol series De worth?

0-750 USD


How much is a Colt Delta Elite 10mm serial DS14593 worth?

I just bought a delta elite for 800. i was told that de serial #s are old manufacture & ds are new manufacture. i do believe colt is making these again.


How much is a colt delta gold cup auto 10mm worth?

Your colt delta gold cup is going for between $900 and $1600 dollars depending on condition where your located, and how bad you want it.


How much is a colt delta elite 10 mm auto gov model serial DS1493 worth?

The value of a Colt Delta Elite 10mm Auto Government model with serial number DS1493 can vary depending on factors such as condition, rarity, and current market demand. We recommend consulting with a firearms appraiser or checking recent sales of similar models to get an accurate estimate of its worth.


What is 10mm in centimeters?

10mm = 1cm


How difficult is it to replace the blend door on a 2007 Chevy Equinox?

You have to take the front dash apart almost to the firewall. A lot of 5,8and 10mm screws. Not a job for a DIY'er.


How many cm are 10mm?

10mm = 1cm.


Which is larger 9mm or 10mm bullet?

10mm


How do you replace a petrol flap Renault Scenic?

Scenic 1.. Inside the rear wing, there are 2 X 10mm nut. Normally covered in road crud. Clean them first and the saturate in wd-40. Leave a while and then undo. If the front of the bolt starts to spin on the inside of the filler flap, you have to either tear the plastic apart to grip the bolt or get creative with pliers.