To take the Armi Galesi Brescia Brevetto 6.35/.25 Auto Apart. Remove the magazine and check the chamber for a round. Lower the safety around while pulling the slide back. The notch that the safety locks into on the slide will give you just enough room to rotate the back end of the safety around 180 degrees. Once the safety has been rotated, a block on the rear of the slide will protrude out. After the block has been pulled as far out as it will allow, pull the slide back carefully and then lift up and away from the frame of the gun. The slide should pop up. Then move the slide forward to allow it to escape the barrel and recoil spring. The firing pin is located inside the slide and it can fall out, so watch it. The recoil spring is attached to the barrel. If done correctly, tada. You're Galesi is now field stripped and ready to do what ever you were going to do to this amazingly simple gun. Hope this helps.
hi the armi-galesi-brescia-brevetto-cal.6.35 shoots a 25 cal
Check the website at gunpartscorp. The brand is Galesi, caliber is .25 Auto, but you will need the model number. The part is called a magazine, not a clip, and they are about $40.
6.35mm is the metric designation for .25 Auto.
Gun show, gun shop
Bescia is the city in Italy where Galesi makes Rigarmi brand firearms. Try searching for Galesi- I do not have a readily available website- sorry.
50-175
I have a model '66 and the round type is .25.
how much?
have a gunsmith do it for you, and you will note the steps involved.
You need a gunsmith
Follow instructions in owner's manual
To take apart the Gecado .25 caliber rifle, you will begin by making sure that the rifle is not loaded. Remove the retaining pin at the base of the barrel and remove the barrel.