i have the same issue, i used a magnet to magnetize the oart that fires the bb and it has worked so far
Pull the cocking lever all the way back. Tip the loading barrel forward and dump out all the BBs check the barrel from behind to make sure it's clear. Close the barrel, aim it in a safe direction push the cocking lever back in place and discharge it.
You can load as many BB into the repeater as it will hold, BUT only one pellet at a time can be loaded into the barrel. One shot one pellet.
Release the clip on the left side and let the slide pop back. Grab the front end of the barrel and push it down. load the pellet directly into the barrel. close the barrel. cock the gun normally and fire. It is a single shot pellet gun.
It is used to reduce the recoil of the rifle and as a grip for cocking the barrel.
They became expert marksmen with their long barrel muskets
Yes
Answer1. Pull the springs back after you turned off the safety.2. Push It back in without pulling the trigger.3. Under the barrel is a black thing push it toward the back of the gun and the top should pop open.4. Load BBS in top hole then close.
More information needed.
On the left side, release the thumb latch and let the slide jump back. grab the very nose on the front of the pistol and tip it down. Load bb's in the top chamber or load a pellet in the bottom barrel (But not both at the same time.) Close the barrel. Pull the slide all the way back and push it forward until it locks. You are now ready to shoot.
A magnet in the seat of the barrel
Unknown
Barrel rolling.