answersLogoWhite

0


Best Answer

You will need to remove the trigger assembly. Once you remove this there is a hollow pin that goes through the hammer as well as the shell feed. REmove this carefully as there is a spring located on the left side that works for the shell feed. Once this is out, the trigger will pull straight out. The hammer braces fit on little pins on both sides of the hammer. pull out the old ones replace both with new ones and carefully put the pin back in. This is a 5 minute job, but this is also a good time to fully clean the trigger assembly. I usually spray it down with brake cleaner, blow it dry and then spray on CLP. This becomes a 15-20 minute job if you do a good job

User Avatar

Wiki User

βˆ™ 11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace hammer braces on a model 390 Beretta semiautomatic shotgun?
Write your answer...
Submit
Still have questions?
magnify glass
imp