Materials needed:
-3 bottles all the same type
-3-4 bendy straws, its up to you how many
-Knife
-electrical tape/Hot glue gun(looks nicer, and holds better)
1)Take 2 of the bottles and cut their ends off
2) Take a cap from one of the bottles and make 3-4 holes in it (depends on the # of straws your using)
3) Put your straws in these holes (bendy side sticking up through the top of the cap) and attach them with your tape/glue to the cap
4) Trip off the excess from the bottom of the cap
5) Attach cap to one of the bottles without a bottle
6) Take this bottle with the caps and glue/tape it to the bottle with a bottom (make sure you take the cap off of the bottle with a bottom ;)
7)take the other bottle without a bottom and place it on top of the one with the bendy straws
8) cut out a hole in the side of the bottom bottle for your slider
AND Wa-la
*Fun Extra Steps!!! (require blunt tube and a spice container)
9) Take blunt tube and cut it so it will fit into the bottom bottle (HORIZONTALLY)
(optional-Cut slits in the blunt tube to mimic a diffuser, which allows for bigger hits)
10) Before attaching it to the bottle, cut a hole in the side of the spice container and attach the blunt tube.
11) Cut hole in the top of the spice container for your slider
12)slide ur blunt tube attached to the spice container all the way into the bottom bottle with just a little bit of the blunt sticking out and tape/glue it
This makes it extra awesome ;) enjoy
To make a percolator bong, you will need a glass or plastic bottle, a downstem, a bowl, and a percolator. Cut a hole in the bottle for the downstem, attach the bowl to the downstem, and insert the percolator into the bottle. Fill the bottle with water to cover the percolator, pack the bowl with your herb, and light up for smoother hits.
It is not recommended to make a bong using a water bottle and straws because the materials may release harmful toxins when heated. It is safer to invest in a proper bong made from glass or other safe materials designed specifically for smoking.
depends on the type of bong; if the bong is home made i.e... with a gatorade bottle then fill it below the hole where the straw is as for a regular bong. i would spend money on that but it should be 1/3 full
To fix a broken bong, you can try using a strong adhesive such as epoxy or silicone sealant to glue the pieces back together. Make sure the surfaces are clean and dry before applying the adhesive, and allow sufficient time for it to dry and cure properly. If the break is severe, you may need to consider replacing the broken part or getting a new bong.
To remove resin from your bong, you can try soaking it in a mixture of hot water and isopropyl alcohol. After soaking, shake the bong vigorously to loosen the resin, then rinse it with warm water until clean. You can also use specialized cleaning solutions or brushes designed for cleaning bongs.
It is possible to smoke crack out of a bong, but it is not recommended as it can be dangerous and lead to overdose. Smoking crack through a bong can deliver a more intense and rapid high due to increased potency and faster absorption. However, this method also carries higher risks for overdose and respiratory issues.
No. 24! for Kobe and 24 inches of bong
That was Billy Joe & the Checkmates - "The Perculator".
haa(;
its a stemless bong just make it milky and pull the slide. it is just like a bong with no downstem
dont do that make a bong
Intel
Intel
Bong!
BONG!
You dont, your in rehab for a reason.
a heat sensor
make a homemade one... it's not that hard