You just unroll is about 3 caps down and insert the first on into the gun. Actually, I think you insert it about half way so the other side of the strip is coming out the other end.
slide the gun openplace the roll on the small metal peg in the gun with the end of the roll towards the muzzle and pointing downthread the end of the roll between the back of the gun and the small metal plate inside the gun (both located just forward of the hammer)pull the trigger a couple of times to feed the strip throughClose the gun and HAVE FUN! I hope this was detailed enough.
slide the gun openplace the roll on the small metal peg in the gun with the end of the roll towards the muzzle and pointing downthread the end of the roll between the back of the gun and the small metal plate inside the gun (both located just forward of the hammer)pull the trigger a couple of times to feed the strip throughClose the gun and HAVE FUN! I hope this was detailed enough.
The model 102 rifle is loaded by removing the cap on the end of the barrel.
Type your answer here... nothing its worthless. hahahaha
A cap gun has no projectile- airsoft does.
To properly load a nail gun, first disconnect the power source and remove any nails from the magazine. Then, insert a strip of nails into the magazine with the nail heads facing outwards. Make sure the nails are aligned properly and securely in place before reconnecting the power source and using the nail gun.
There is no set age limit for cap gun ownership.
Nothing. A cap gun has no bullets, it just makes noise.
you can't!
while you use the gun,after using it open,the cap gun put water on it. if it did,nt go you can use cloths
Cap guns don't have bullets.
in a STRIP CLUB DERin a STRIP CLUB DER