buy swivel stud's and a sling. drill holes into the stock and put the studs into it. then attach the sling. (your gun might already have studs in it)
How to install a swivel TV mount would probably depend on the type of TV you bought and the instructions for it are probably in the owner's manual. If not you can look up your product at www.Bestbuy.com
You can only install studs on tires that are designed to accept studs.
The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.
While it doesn't necessarily require studs to install I would suggest you do because depending on the weight of your TV if it is not screwed into studs it could rip out of the wall.
Yes
Practically no. By the time the studs are worn out, tires are too worn for you to install new studs and even if you could, the cost of replacing them would be more than the tires are worth.
I would frame that part of the wall with wood.
Get a good stud finder and make a drawing of where the studs are. Get a good 'pin nailer' and compressor , then attach the sheets to the studs with 1. 9 " nails .
Gun shop, gun shows, catalogs, want ads.
Get a good stud finder and make a drawing of where the studs are. Get a good 'pin nailer' and compressor , then attach the sheets to the studs with 1. 9 " nails .
first install new carb gasket to intake manifold and then 4 nuts hold the carb to the intake studs and then install the throttle linkage to the carb.