not all rings with balls have to screw on, it depends what typre you're talking about some times i get the confusion when some wank stain calls a stud a ring, guessing that its a ring, its not always a screw on ring, my lip ring you clip the ball in, there is a hole running through the ball and out the other side and you put one side of the hole on one side of the ring and clip in the other side. hope this helped, next time ask the person who sells it.
Yeah. Some tongue ring balls are pretty big and may look tacky on lip rings.
It can be tricky. You'll need ring closers. If you only have pliers, wrap some medical tape around them so that you don't scratch the ring. My explanation might be difficult to understand so maybe search youtube for tutorials. -before you put it in your lip, tighten or open the ring just enough so that the ball will pop in and out easily-there are dimples on the ball -put the ring in your piercing then slip the ball into place - tighten the ring so that the ball doesn't slip out -the end :3
labrets is the typpe of jewelery used for your lip piercing. they have a flat back on one end and a ball n the other. the flat part is put inside your lip and the ball is the decoration on the outside :D
It probably won't but it can. Your piercer should put the ball in there pretty tight but if the ball does pop out the ring could slip out.
Well , if you want to put in the labret What you do is you Take off the little ball or stud at the end and set it aside , then pull your lip forward and put the screw part through your hole from the inside. If you haven't got the right gauge what i did was i put the screw part from the outside and the stud from the inside to break the skin , then it was perfect Happy Piercing xx Iris.
Just take the ball/bead out of it and put the ring on your lip. If the diameter of the ring is too long, it may not look realistic but just give it a shot. You can't do much else with it.
Place the ring then place the captive bead over the seam
yeah you should be able to, as long as the lip ring is the same thickness as the stud you had your nose pierced with, otherwise the ring will not go through. :) hope this helped.
hi. usually there is a little ball at the top of the ring, you unscrew it, it should be flat at the top, not pointy. you then slip it in your "hole" and screw the ball back on the top securly .
sorry, you can't
I think you're describing a Captive ball/bead ring. Its really difficult to explain by typing it out and can be tricky to figure out for the first time. The best thing is to look up videos on how to open/close a CBR on youtube or something like that.
If you still have the silver ring that surrounds the ball then pick up the ball, place it inside the ring and snap it back into the hole it came from. If you don't have the silver ring... better look for it... cos if you dont have it or its broken... you're screwed! Take care, the ring has little clips on it that have to be carefully lined up. Have a good weekend... Alex