How do you disassemble a rigarmi cal 25?

Answer 1

WARNING!! UNLOAD WEAPON!!! remove clip, visually inspect weapon to verify it is not loaded,by pulling back slide and look into feed to verify that weapon is not loaded.dry fire weapon to release firing pin spring.on the left side of weapon behind the grip there is a safety with a white and a red markings.swing the safety all the way around backwards,that is turn it to point down and around to point to the back of the weapon.at that point the weapon is ready to disassemble.point the weapon up und lightly tap with with palm to cause the serrated safety retainer ( the small double rounded hourglass shaped part on the back behind the slide) to slide back,thereby releasing the slide.you may have to pull on the slide as it may be tight from non removal over time.once the safety retainer is back as far as it will go(about half inch) the slide will be ready for removal.pull slide back about one quarter inch carefully and lift it off the frame up slowly and allow the recoil spring to push the slide forward untill the slide is fully off the frame. do this very slowly so no damage is done.when reassembling use a bic pen inserting it into the end of the slide and then inserting the pen into the barrel ,so as to guide the barrel back in place while making sure not to damage the spring or the slide.do this slowly. assemble in reverse from this point on.and there WA-LA.!! AS EASY AS ROCKET SCIENCE!!! D.T.