You connect your floor shifter to your transfer case in a 4x4 Chevy truck 1993 by getting under the truck and looking for the rod that comes from the shifter to the transfer case. Then, use the pin connector to connect the rod.
Both. The Monte Carlo SS had a floor shifter (what I own), but the regular monte's had column shift
if there is a body lift on it then you will need to cut your floor board if not then check the linkage on your shifter if that is good then something is wrong with your transfer case
It was an option, yes. Both column and console shifters were available during that production run.
Automatic Floor Shifter - 25 results like the 6423 Shifter Automatic, B & M 81011 Street Rod Shifter Auto Trans Shifter Kits, 3160009 Quarter Stick Shifter ...
a part of a car
you will have to take the console out or at least the top piece of the console and then you will see the shifter is bolted to the floor.
passenger side floor bord
there are 2 diffrent kinds of shifter cables out there & they dont tell you !! One is for floor shifter & other is for on the tree !! both have size diffrence so make sure you tell them what you have at parts store or local auto wreckers !!
I just did this in my '86 because the transfer case would not shift I had to remove the shifter and realign the two shifting rods inside to get it out of neutral. Pull the shifter boot off the floor. Pull up the transfer case boot under the floor boot. remove the shifter by using a couple of screwdrivers to push down on the ring around the shifter at the bottom and turn CCW (1/4 turn), this will release the spring loaded catches that hold the shifter in (don't worry you will not lose anything). When you extract the shifter you will see the 'ball' on the shift lever, the shifter sheet is what this ball sits on inside the transfer case. It is a cupped shaped piece of plastic like nylon and is often long ago disintegrated and missing, if not, pull it out and put in the new urethane or brass sheet and put everything back together. Hints: be sure to eliminate any burrs on the shifting ball that will cause premature failure of the sheet by filing them off.
More then likely the shiften rod from the floor shifter poped off of the transfur case. Slide up under the truck and look up at the floor where the shifter comes through it and you will see a rod. See if it's hooked up on bothe ends.
how to remove trans shifter cable ball socket from shifter ball
The shifter has splines that need to be lubed get under the truck and spray the floor shifter mecanism and have someone move the shifter as u spray should free up then lube the linkage