answersLogoWhite

0

Check gunpartscorp website, under H for Herbert Schmidt, and check under small frame. There are still SOME parts available for these.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How much does it cost replace a cylinder?

Need more info, such as what cylinder you are asking about, wheel cylinder, key lock cylinder, engine cylinder and what year, make and model vehicle.


Need the spics on amadeo rossi m59 22mag?

I need the parts diagram on Amadeo rossi Sa Model59 22MAG ?


How do you install the ignition lock cylinder on a 84 Chevy blazer?

You will need to attach the wiring harness to the end of your 1984 Chevrolet Blazer ignition lock cylinder. Slide the cylinder into the cylinder slot. Secure the ignition lock cylinder with the retaining ring.


How do you remove a lock cylinder for a 1988 gmc jimmy?

if it is the ignition lock cylinder, first disconnect the battery, you need to remove the steering wheel ,turn signal switch , etc, then you need to insert the ignition key into the lock cylinder, turn it to the run position,then pull the cylinder out, reverse the operation to install the cylinder,


How can I rekey a Kwikset lock?

To rekey a Kwikset lock, you will need a rekeying kit that matches your lock model. Follow the instructions provided in the kit to remove the lock cylinder, replace the pins to match a new key, and then reassemble the lock. It is recommended to watch tutorial videos or seek professional help if you are unsure.


How can I rekey a Schlage deadbolt lock?

To rekey a Schlage deadbolt lock, you will need a rekeying kit that matches the specific Schlage lock model. Follow the instructions provided in the kit to remove the lock cylinder, replace the pins to match a new key, and then reassemble the lock. If you are unsure or uncomfortable with the process, it is recommended to seek the assistance of a professional locksmith.


How do you fix a lock cylinder on a 74 nova with out the key?

you need the key to fix it.


How do you get the door lock off to make a new key on 1989 bronco 2?

To remove the door lock cylinder from a 1989 Bronco II, you'll need to start by removing the door panel to access the lock assembly. Once the panel is off, locate the retaining clip or screw that holds the lock cylinder in place. After removing it, you can pull the lock cylinder out of the door. You can then take the cylinder to a locksmith to create a new key.


How do you remove and replace an ignition lock cylinder on a 96 ford ranger?

after you take the plastic cover from around the steering colum, under the lock cylinder there should be a small access hole. you'll need a long thin tool to push up in there. on the cylinder lock itself there is a little pin that needs to be pushed in so the cylinder can be pulled out.


Need removal and installation instructions for an ignition cylinder 2000 Grand Cherokee Jeep?

Need removal and installation instructions for an ignition lock cylinder -- 1999 Grand Cherokee Limited?


How can I rekey a Kwikset lock without a key?

To rekey a Kwikset lock without a key, you will need a rekeying kit that matches the specific model of your lock. Follow the instructions in the kit to remove the lock cylinder and pins, then insert the new pins to create a new key combination. It is recommended to have some experience with locksmithing or seek professional help to ensure the process is done correctly.


Do you need to remove steering wheel to replace key lock cylinder on a 1983 jeep cj7?

Yes.