If you understand that concrete is a porous material that absorbs and has moisture in it, you then should also understand that this moisture will move toward the top surface of a concrete floor. This moisture will promote mold growth and will also destroy the bond of of most adhesives.
Membrane coatings are prone to failure when this moisture carries alkali in concrete to the surface. You are much better off using a penetrating sealer such as "StableCrete" to waterproof the concrete. This product penetrates to form a solid in the capillary/gel-pore system of a concrete. This stops moisture migration and provides for a superior bond to the concrete.
If the drywall is directly onto the concrete, drill into the concrete and use a shield and screw or there is a concrete screw called Tapcon that screws directly into the concrete without a shield and holds much better. If the drywall is on furring strips, either mount the banister on the strips or go through the strips into the concrete.
The top layer of concrete is called the structural coat. It directly receives the most load which must then be transferred to lower layers.
You can set the joist directly into a 3 or 4 foot hole filled with concrete, however the life expectancy of the joist is about half when it does not come in contact with the ground at all. On my house I set them on metal brackets then epoxied the bracket bolt into the concrete. With pressure treated lumber this post will be "good as new" for 25 years. Depending on the area I have seen concrete ones disintegrate in 3-8 years.
You should not weld on concrete, as it can explode if heated
I don't have an answer but we have several large magnets in the shop I work in. It would appear that when we lower the cranes down and place the magnets directly on the concrete floor it tends to weaken them. I have always heard that placing a car battery on concrete would weaken the battery . Does a magnet act in the same fashion?
The best flooring options for installing over concrete are laminate, vinyl, and engineered hardwood. These materials are durable, moisture-resistant, and can be installed directly onto concrete without the need for a subfloor.
Yes, you can install tile directly on concrete by using a suitable adhesive or mortar to bond the tile to the concrete surface. It is important to ensure that the concrete is clean, level, and free of any cracks or imperfections before installing the tile.
Reviews on the Sony Xperia C doesn't seem to indicate if it is waterproof. Best bet is to contact Sony directly to confirm if it is waterproof.
Yes, you can lay tile directly on concrete by using a suitable adhesive or mortar to secure the tiles in place. It is important to properly prepare the concrete surface before tiling to ensure a strong and durable bond.
The most popular brand of waterproof box is made by Otterbox. One can purchase directly online from Otterbox as well as Amazon. They can be found used on eBay.
If the drywall is directly onto the concrete, drill into the concrete and use a shield and screw or there is a concrete screw called Tapcon that screws directly into the concrete without a shield and holds much better. If the drywall is on furring strips, either mount the banister on the strips or go through the strips into the concrete.
concrete ingredients are directly feed in to the mixture plant and mixing done by means of machine. And it is pumped by means of concrete pump and placed in the site.
It is heavy. After it dries, it is hard. Actually, drying is not directly linked to hardness in concrete. After concrete is poured, putting it in a wet environment by spraying it constantly with water will hasten its hardening and its curing. After concrete cures, it is hard.
The best flooring options for a concrete basement are vinyl, laminate, or engineered wood. These materials are durable, moisture-resistant, and can be installed directly over concrete.
There are not waterproofing products available, but you can buy waterproofed briefcases directly from a manufacturer.
Yes, force is a concrete noun because it refers to a physical entity or phenomenon that can be directly observed or experienced through the senses.
The top layer of concrete is called the structural coat. It directly receives the most load which must then be transferred to lower layers.