0
Add your answer:
Earn +20 pts
What is differential beam bending?
Differential beam bending is when the beam is being bent at equally but at opposite sides. The beam can be bend in separate areas of a single beam or be two different parallel beams.
What is difference between beam and channel?
The channel is U-shaped cross-section, while the crossbeam is can be divided into H-plate, I-beam, etc. Both of them have different uses.
What is Minor axis of a rectangular column or beam?
The minor axis of a rectangular column or beam is the line that goes through the center. The minor axis will be shorter than the major axis.
What is max span using a 4 by 12 beam?
The answer to this question is too complex to describe here. There are too many factors which are not specified in the question, such as load in pounds per linear foot, spacing of the 4X12 joists, as well as grade and species of lumber.
What are two examples of a parallel beam of light?
What are two examples of a parallel beam of light
What is the difference between plinth and tie beam?
A plinth refers to the base that a column rests on. Tie beam refers to a beam that connects two or more columns, that acts as a stiffener.
What is the definition of plinth beam?
plinth beam is a part of a structure can transfer loads to the adjacent columns
Why should you provide a plinth beam?
Plinth beam is provided to 1. support the wall above it 2. act as tie beam for columns
What is the normal size of a plinth beam?
The normal size of a plinth beam is typically between 9 inches to 12 inches in thickness and 9 inches to 12 inches in depth, depending on the structural design requirements and load-bearing capacity needed for the building.
What is plinth protection?
Plinth protection is the additional length or strengthening provided in the lowest portion of a beam or the lower portion of a foundation/floor by providing additional thickness/height.
Should there be a bed under a plinth beam?
Firstly, it is more appropriate to call this type of beam a "grade beam". It is not mandatory to provide a bed (of PCC or brickwork) beneath a grade beam in framed structures. However, it is advisable to provide one under the following conditions or when considering the following circumstances: 1. Unevenness of the ground on which the beam is laid. 2. Reducing cover to reinforcement for structures in contact with soil. 3. To prevent erosion of disturbed earth from below the beam. 4. Mobilization of elastic support throughout the length of the beam in the event of an over-load such as support settlement or earthquakes.
How long is a beam routine for grade 14?
it can be as long as you want it to be.. but it can't be more than 3 lengths of the beam
What grade of concrete use in column and slab?
as per ACI , the ratio between column & beam concrete grades dont exceed 1.4
What is the logical application of grade beam foundation construction?
Grade beams works as frame and take the load of slab and diverse to the ground
What is the difference between inverted beam and drop beam?
An inverted beam is a beam whose bottom is the same as the slab. A drop beam is a beam that is put under the structural member it supports.
What is rcc beam?
Rcc beam is supported between two support to carry the structure
What is the difference between a column and a beam?
A beam will be placed horizontally, a column will be placed vertically.
