0
Add your answer:
Earn +20 pts
How do you hook up aftermarket stereo in 1977 Lincoln?
on factory wire harnes, there are 5 speaker wires. 4 are (+). on speakers, but only one (-). when i hook up aftermarket head unit do i hook up all negative speaker wires together
Can you hook up sub woofers to the stock stereo in 1997 s10 blazer?
yes, you have to go to your local stereo dealer and get a line converter. that will convert the regular speaker wires to rca which is the preferred way to hook up an amp
How do you hook subs up to your factory stereo?
Use a line out converter spliced into the rear speaker wires to connect RCAs to a sub amp.
How do you hook up stereo speakers to a truck stereo?
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.
How do you hook up a mono block amp?
the difference between a mono block and stereo amp is this: a stereo amp sees half of ohms you give it ( that is if you are trying to bridge it), the mono block see whatever ohm load you give it.
Where do you hook up your remote wire from amp to stock stereo for a 2006 Chevy Malibu?
You can buy an adapter that hooks up to the speaker outputs and generates a true turn on lead or you can hook it up to ignition (pink) at the key switch if you want to save money.
Can I hook up all my 8 speakers to a 4 speaker car stereo?
no because there not enough, yes because you could put four in then take them out and put the other four in.
How do you measure volts amps and ohms?
Preferably with a multimeter. For amps you hook it up in series, for volts you hook it up in parallell. For Ohms, you'll need to have the item you want to measure separated fron the circuit.
How do you hook up an vr3 200 watt 2 channel amp to a car stereo?
well you hook it up
How do you hook up house stereo in car?
with ur hands
Do you need a professional to do stereo equipment installation?
No, you do not need a professional to install stereo equipments. This is because stereos installation is not very hard. You will require some speaker wires and hook them all up to a receiver. The receiver will then need an audio input from a source.
How do you hook up fractory stereo to amp?
With a line output converter. Converts high level speaker outputs to low level line (RCA) inputs. Raptor install accessories part #LOCA25.
