Remove magazine. Pull back slide inspecting chamber. All ammunition must be removed. Draw slide back till slide cut on lower left edge is centered over the round frontal area of slide stop. Push slide stop out of frame from right to left while holding slide so that the cut is over the pin. after slide stop is out and on table gently guide the slide forward and off the frame. Set slide on table so sights are down. Recoil rod and spring assembly is pulled up after compressing a little. Barrel can be removed at this time. Assembly is reverse order.
No
Try S&W web site.
The Smith & Wesson Model 1076 is a semi-automatic pistol, and detailed disassembly and assembly instructions can typically be found in the owner's manual or through reputable firearms resource websites and forums. For disassembly, ensure the firearm is unloaded, remove the magazine, and follow the steps to take down the slide and frame. Assembly involves reversing the disassembly steps while ensuring all parts are properly seated and secured. Always prioritize safety and, if unsure, consult a qualified gunsmith.
Best left to a trained gunsmith. For normal cleaning, no disassembly is needed.
I have a complete set of photos where you can see how to assembly and disassembly your pistol. If you are interested, send an e-mail to massud@uol.com.br
Take it to a gunsmith
it is a Model 39-2 9mm pistol
Smith and Wesson 6909 Stainless steel semi-auto pistol stopped produvtion in 2001
Smith and Wesson is the make.
The Gun Digest Assembly/Disassembly book for semiautomatic pistols may have that gun. If not, try the American Rifleman book of pistol disassembly - I'm pretty sure I have seen it there. go to www.e-gunparts.com they have exploded views of most guns that you can print free
No
yes.