answersLogoWhite

0

What else can I help you with?

Related Questions

Is a size 16 gauge the same thing as a regular ear piercing hole?

It is normal for a lobe piercing to be 16 or 18 gauge... but it is normally 18. A 16 gauge is normally used for tragus piercings :)


Can you adjust a 14 st gauge knitting pattern to a 12 st gauge by changing the size of needles used - up or down a size?

If you want to go from a 14st gauge to a 12st gauge, you need larger sizes needles.


What size gauge or mm is an average nose piercing?

For a standard nostril piercing, 18 g.


What size gauge do you pierce septum with?

The standard starter size for a septum piercing is 14g.


What size gauge needle do you use to start iv in an infant?

Butterfly needles


Are piercing earrings the same size as regular earrings?

Most studs are either 20ga or 18ga. Piercing shops will most likely pierce them at 16ga. Its perfectly fine to wear smaller gauge jewelry than what the piercing was done at.


Is a 16G or a 14G tongue piercing bigger?

14 gauge is bigger, the lower the gauge size, the bigger it is


What gaude is a labret?

This all depends on what size needle your piercing artist uses when performing the piercing. But after your piercing is healed, you can stretch the gauge size bigger to fit other jewelry. C:


How much does it hurt to get your ear lobes pierced with 10 gauge rings?

a lot if u want to get size 10 gauge u should get the normal ear piercing size which is a size 20 or 18 gauge and slowly gauge it to a size 10 gauge


What size needle is used for rutine venipunture?

Safety needles will be 22g or less. Butterfly needles will be 21g or less.


Will a zero gauge piercing close?

It depends on the person most of the time a piercing that is stretched to a 0G will close to they original piercing size if you take the jewelery out.


Is a 16 gauge the same as a regular earring?

No. The common, plain old, earring size is almost always 22 Gauge. 16 Gauge is just a bit smaller than the common piercing size of 14 Gauge. The size chart goes down in increments of two from 22 usually down into the negatives of 00 gauge, and then breaks down into diameters.