Below the steering wheel. It will have 16-pin but not OBD2 compliant. You will need an adapter to convert the to OBD2. The engine (presumably) Mitsubishi 4G15 Efi which originally 12-pin. Proton did not use 12-pin but maintain the 16-pin where 4 pins are not used.
In a Proton Wira, the fuse box is typically located under the dashboard on the driver's side. It may be a rectangular or square-shaped box with a cover that can be easily removed to access the fuses. Refer to your owner's manual for the exact location of the fuse box in your vehicle.
The best fuel for a 4G93 DOHC 16 Valve engine is typically premium unleaded gasoline with an octane rating of 91 or higher. Using higher octane fuel can help optimize engine performance and prevent knocking or pinging. It is advisable to refer to the manufacturer's recommendations for specific fuel requirements.
Proton Wira was created in 1993.
The Proton Wira firing order is 1-2-3-4 for the four-cylinder VDO engine. This fuel injected engine came into use in 1991 and is slightly different than previous models, some of which included carburetors.
50ft. lb
A forklift training video is filmed in omaha. It is a video of saving a proton wira with a forklift. But the fact is that proton wira is not worth of even the fuel cost of forklift
The Malaysian automotive company Proton released the Proton Wira in 1993 and continued to produce them until 2007. The car was made in two different styles, the first being a four-door saloon and the other being a four-door hatchback.
if indicator flasher is signal relay then its underneath dashboard, driver's side..
In a Proton Wira, the fuse box is typically located under the dashboard on the driver's side. It may be a rectangular or square-shaped box with a cover that can be easily removed to access the fuses. Refer to your owner's manual for the exact location of the fuse box in your vehicle.
WIRA was created on 1996-11-01.
Wira Gardiner was born in 1945.
Brad Wira was born on 1972-03-16.
most modern cars have the sensor or sender [as its commonly know] with the fuel pump in the tank..to get it them you need to find where there is an inspection cover [commonly under rear seats] undo it and withdraw the pump along with sensor and usually filter as well these days..
In a Proton Wira SE 1.5, the fuse for the reverse lights is typically located in the fuse box under the dashboard on the driver's side. You can refer to the owner's manual for the exact fuse number and location. Additionally, there may be a fuse box in the engine compartment, so it's worth checking both areas if the reverse lights are not functioning. Always ensure the vehicle is turned off and disconnect the battery before inspecting or replacing fuses.