There are 2 catalytic converters on a V8 2002 Toyota Tundra. Bank 1 is the manifold and cat on the drivers side and bank 2 is the manifold and cat on the passenger side. Sensor 1 is the sensor on the exhaust manifold before the catalytic converter. Sensor 2 is the sensor located after the cat converter. Bank 2 Sensor 2 is the sensor located after the catalytic coverter on the passenger side.
Yes, a space heater can be plugged into any outlet. Depending on what else is drawing current on the circuit will govern whether the circuit will trip or not. If the heater is plugged in and the circuit does not trip it can be left plugged as long as it is needed. If the heater trips after a few seconds, then try another outlet.
An immersion heater typically requires a dedicated circuit with a Miniature Circuit Breaker (MCB) rated at 16A or 20A, depending on the power rating of the heater. It is recommended to consult with a qualified electrician to determine the appropriate MCB rating based on the specific requirements of the immersion heater.
If your circuit breaker has tripped and will not reset after a heater overload, it is essential to disconnect the heater from the circuit and try resetting the breaker again. If the breaker continues to trip, there may be a more significant issue with the heater or the circuit, and it is recommended to contact a licensed electrician to assess and repair the problem to prevent any potential hazards.
It is generally not recommended to repurpose a dedicated circuit that was originally installed for a specific purpose, such as a heater, for a different use like lighting. This could lead to issues with overloading the circuit, causing safety hazards or violating electrical codes. It is best to consult with a licensed electrician to determine the best course of action.
A 3 kW immersion heater circuit should be provided with a dedicated 15 Amp circuit that is protected by a 15 Amp circuit breaker and wired with appropriately sized cables (typically 14 AWG for residential wiring in the US). Additionally, a Ground Fault Circuit Interrupter (GFCI) protection may be required for safety.
Load circuit
The Toyota Camry block heater is located on the front of the engine block. You can follow the block heater cord to the block heater.
In 2012 about $40
The O2 sensor heater circuit helps warm up the O2 sensor. The purpose of this is to allow O2 sensor to get to normal operating temperature without having to wait for exhaust pipes to warm up so it can give accurate readings. It is built into O2 sensor.
The block heater is located near the engine on most cars. This is true also for the 2003 Toyota Rav 4.
Bank 2 locates on the opposite side of the cylinder # 1 and the sensor 1 is locates in the front
== ==
Heated oxygen sensor heater circuit malfunction (bank 1, sensor 1): Open or short in heated oxygen sensor heater circuit Heated oxygen sensor heater malfunction (Haynes Repair Manual)
behind the dashboard on the passengers side
Located at the evaporator inlet which is under the dash in the heater/AC housing.
Passenger side, interior, near firewall.
Under the dash in the heater?AC housing.