2 amps
Using larger wire sizes will not reduce amp draw. The amp draw is determined by the electrical device or load connected to the circuit, not the wire size. Larger wire sizes are used to reduce voltage drop and heat generation in the wiring, but they do not directly affect the amp draw of the circuit.
The maximum voltage you can draw from a 32 amp socket depends on the voltage rating of the socket. For example, if it is a standard 240-volt socket, the maximum voltage you can draw is 240 volts. It's important to check the voltage rating of the socket to ensure you are not exceeding its limits.
The voltage would be the same even if you installed three washing machines. The amp draw is what will change. An automatic washer uses about 120 volts at about 700 watts, so your washer would draw a little less than six amps. It is recommended that it have a dedicated 20 amp circuit. If you install a dryer then the voltage requirement would be about 240.Rate
It depends on the capacity of the circuit. A typical residential circuit in the US is rated for 15 or 20 amps.
On a 15 amp breaker, you can draw up to 120 volts in a standard residential circuit. The voltage remains constant at 120 volts, but the amperage capacity is what is limited by the 15 amp breaker.
Using larger wire sizes will not reduce amp draw. The amp draw is determined by the electrical device or load connected to the circuit, not the wire size. Larger wire sizes are used to reduce voltage drop and heat generation in the wiring, but they do not directly affect the amp draw of the circuit.
The iMac is very energy efficient. A typical iMac will draw around 150-200 watts when in use so you can easily connect 8 iMacs to a 20 amp circuit. This would equate to a 80% draw on the circuit. I would not recommend any more than 8. That is assuming nothing else is on that circuit.
Clipping occurs in the voltage waveform when the input voltage, multiplied by the voltage gain of the op-amp circuit, exceeds the op-amp supply voltage as limited by the output network. The supply voltage and output network, limits the maximum voltage that can be achieved at the output. The op-amp behaves normally within its range of maximum voltage output, and then it is clipped when it reaches the maximum voltage of the circuit.
The maximum voltage you can draw from a 32 amp socket depends on the voltage rating of the socket. For example, if it is a standard 240-volt socket, the maximum voltage you can draw is 240 volts. It's important to check the voltage rating of the socket to ensure you are not exceeding its limits.
That depends on the voltage.
If it is then it has a 3 or 5 amp fuse. Some are not.
The voltage would be the same even if you installed three washing machines. The amp draw is what will change. An automatic washer uses about 120 volts at about 700 watts, so your washer would draw a little less than six amps. It is recommended that it have a dedicated 20 amp circuit. If you install a dryer then the voltage requirement would be about 240.Rate
Yes. A twenty amp circuit just means the breaker (fuse) will kick in if you draw more then 20 amps, but its fine to use at less amperage.
It depends on the capacity of the circuit. A typical residential circuit in the US is rated for 15 or 20 amps.
On a 15 amp breaker, you can draw up to 120 volts in a standard residential circuit. The voltage remains constant at 120 volts, but the amperage capacity is what is limited by the 15 amp breaker.
Any appliances that draw over 1500 watts should be on a 20 amp circuit.
Divide 25,000 by the supply voltage to get the current.