The maximum height of the dryer plug from the floor should be 1.5m.
Answer for USA, Canada and countries running a 60 Hz power supply service.In US the max height from the floor to the top of the switch is 48". Answer for countries in Europe and other world areas running a 50 Hz power supply service.For UK current standards (17th edition) the top of the switch can be no higher than 1200mm from finished floor level, nor the bottom be less than 450mm from finished floor level, so anywhere between these that suit your needs would be fine. The correct answer to your question will depend on the exact location of the light switches in particular if the location is subject to damp conditions, such as in a bathroom, shower room, kitchen or anywhere outside a building.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
Yes, to check continuity on a thermal disc for a gas dryer, you will need to use a multimeter set to the ohms setting. Disconnect the thermal disc from the dryer and touch the multimeter probes to each terminal on the thermal disc. If the multimeter reads a resistance value (usually between 0-200 ohms), then the thermal disc is functioning properly. If it reads "OL" (open loop), then the thermal disc has continuity and needs to be replaced.
The maximum amp rating of a L5-30 plug is 30 amps. It is commonly used for high-power equipment such as generators and large appliances. Make sure to check the specific requirements of your equipment to ensure compatibility.
To find the mass of the pendulum, we need to use the conservation of energy principle. At the lowest point of the swing, all of the potential energy is converted to kinetic energy. So, equating the two energies we have: mgh = 1/2 mv^2. By substituting the given values, we can solve for the mass of the pendulum.
The lambda max is 510 nm.
The ADA required height for access to paper towels requires that the dispenser be fifteen inches to forty eight inches above the finished deck. This is defined by Title III of the ADA.
max height 950 mm max width1800 mm with tires
Max height 13'6 for states east of the Mississippi river, max height 14'2 for states west of the Mississippi river.
Hood is usually measured in a range of 30 inch min to 36 inch max from the stove top. Hope that helps.
Most toilets are between 14 and 16 inches from the ground. There is also another height specification available, which is called handicap compliant height. This height is mandatory for medical handicap toilets supply. The height of this toilet can vary between 16 ½ inches and 18 inches.ANSI 117.1a 2003, which is determined to be "SAFE HARBOR" for accessible design, requires that an accessible toilet be 17" to 19" in height.
Nudge is close to Max's height.
The max height depends only on the angle and speed at release. It doesn't depend on the projectile's weight.
Also known as ADA toilets for disabled people, the rim of the toilet is a minimum 16-1/2" inchs off the finished floor, up to a max of about 18.
it does not matter what age you are, It's the height and the height it is. The height is 130cm
Go to a hardware store.
6 Foot max.
5'7'' max.