0
What else can I help you with?
How do you fix a slight leak going into the valve from the copper pipe you noticed when removing a radiator?
if it is a slow drip or sepage, it will make, @ particles in the water will fix it, if it is a steady drip then you will have to take it apart and wrap the pipe fitting with teflon tape, or use a pipe sealer on the threads,
How do you turn on your natural gas at the meter?
You can't miss the shut off valve on the main line close to the pressure reg just before the meter.Should have a hole in it and behind it is another hole, this is so it can be locked by your power company. If the holes match it is off,rotate it 45deg or in line with the pipe. Everything on this planet for a valve is on when in line with the flow of pipe and when its at a right angle to pipe it is off.
How many one inch pipe equals for one four inch pipe for water distribution?
It would take sixteen one-inch pipes to equal the cross-sectional area of one four-inch pipe. This assumes the pipes are circular in cross-section.
How long will it take to flow 300 gallons through a 1 inch pipe at 55 lbs psi?
The time it takes to flow 300 gallons through a 1 inch pipe at 55 psi depends on the flow rate of the pipe. You would need to know the flow rate in gallons per minute (GPM) of the 1 inch pipe to calculate the time it takes. Without the flow rate, it is not possible to determine the exact time it will take.
Definition of branch pipe of a volcano?
A branch pipe of a volcano is a smaller conduit that branches off from the main vent of the volcano. Branch pipes can be found on the flanks of a volcano and may act as secondary pathways for magma to reach the surface. They can contribute to localized eruptions and can play a role in the overall plumbing system of a volcano.
What are the tools needed for pipe take off?
pipe rench
What does take off of pipe mean?
No
What is the take off formula off 45 degree elbow pipe?
The take off formula of a 45 degree elbow pipe, will depend on what the pipe is on. Sometimes a 45 degree pipe will need a 90 degree right angle turn to come off.
What is the take off for a six pipe?
6"
What is the take off for a six pipe spool?
6"
What is the formula to find take off for 30degree elbow?
The take-off for a 30-degree elbow can be calculated using the formula: Take-off = Pipe Diameter × 0.577. For example, if the pipe diameter is 4 inches, the take-off would be 4 × 0.577 = 2.308 inches. This formula helps determine the horizontal run of the pipe after the elbow joint.
What is the formula of takes off for 30 degree pipe elbow?
this app help you: "Miter Flat Pattern Design" in play.google.com
What is the take off for a six inch pipe?
Three inches
What is take off measurement for 90 degree 8 inch pipe?
The take-off for a standard radius 90 is one and one half the diameter of the pipe. Example: 6 inch 90 has a take- off of 9 inches. The take-off for short radius 90 would be the dia. of the pipe. Long radius 90 is 2 times the pipe diameter.
What is the take off of pipe mean?
The "take-off" of a pipe refers to the point where a branch pipe or fitting is connected to a main pipe, allowing for the diversion of fluid or gas flow. It involves the angle and design of the connection, which can affect the flow characteristics and pressure within the system. Properly designing the take-off is crucial for maintaining system efficiency and preventing issues like turbulence or pressure drops.
Take off sizes for pipe fabrication?
There is actually no question here
What is the take off for an 8-inch pipe?
4 5/16
