The amount a you can tighten a fastener with out a tool.
This is about 2 Nm
You won't find a torque labeled in "inch foot pound". It'll either say "inch-pound" or else "foot-pound". In either case, you probably can't achieve 80 of them without using a tool to tighten it.
Your ring finger is the finger between your middle finger and your pinky.
A major finger, also known as a central finger, is the longest finger on the hand. In human anatomy, it is usually the middle finger.
The little finger, also known as the pinky finger, is the smallest finger on the human hand.
Yes, the pinky is considered a finger. It is often referred to as the little finger or pinky finger.
finger tight then half turn with plug Socket, because most people don't have a torque wrench
When the plugs are finger tight, tighten them with a ratchet 1/16 of a turn.
just put it on finger tight, if it breaks down then get a real car.
loose when its around your finger but tight when you pull it :)
Torque is not the type of bolt but a type of wrench used to tighten bolts. A torque wrench will tell you how tight a bolt is tightened like 60lb of torque or tighten to 80lb of torque so a bolt will be tight enough to stay in but not too tight that you strip the bolt.
Tight is tight... get it snug, roll with it.
Your ring should be just tight enough not to slip too easily off your finger. A too tight ring can cause restriction of blood to the finger tip.
I'm not for sure the actual torque specs. I go just past finger tight. I will warn you tho, that those screws are prone to stripping out. So if you over tighten you might find yourself having to drill and tap further in.
the torque is F.T. [f***ing tight] onset
you torque the bolts until they are good and tight
Get ALL of them finger tight or just a whisker tighter. Then criss-cross your way around the pan. DO NOT OVERTIGHTEN. You'll crush the gasket.
yes it hurts, I've had experience, If its 1 finger then its not bad, but if your tight and they put another finger it will be sore.