What happens if you plug a 110v appliance into 220v outlet?

Answer 1

for USA, Canada and countries running a 60 Hz power supply service.It is important that you should read see the answer to the Related Question shown below.

<><><>

It won't run, there is insufficient start up voltage. It's all in the way the windings in the motor are connected. Since I'm an electrician, I just haven't done this because I always do something to make it right i.e. change the input voltage or change the connections of the motor windings. I would suspect the most it would do is buzz. Just a guess.

If in doubt, consult a qualified electrician to have it rewired if it's dual voltage or change the power source to accommodate your motor.

<><><>

As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.

Before you do any work yourself,

on electrical circuits, equipment or appliances,

always use a test meter to ensure the circuit is, in fact, de-energized.

IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB

SAFELY AND COMPETENTLY

REFER THIS WORK TO QUALIFIED PROFESSIONALS.

Answer 2

If you plug a 110v appliance into a 220v outlet, you risk damaging the appliance due to the higher voltage. The excess voltage can cause the appliance to overheat, burn out, or even catch on fire. It is important to always match the voltage requirements of the appliance with the voltage of the outlet to avoid damage.

Answer 3

some devices such as cell phone chargers wont mind, but others, such as portable music devices, household appliances etc will instantly die. If you manage to get a 110 configured plug into a 220 volt plug configuration, you would trip the breaker on overcurrent.

Answer 4

If you are lucky, and the unit has a switching device, nothing. If it doesn't, then you will more than likely notice a "fizz" and a burning smell. If left, the smell will get worse, and if you are lucky then, the unit will fail, if you are very unlucky, the unit could start to burn.

Hopefully the fuse box, will cut in, otherwise you could have a fire on your hands, and if not attended to, you could loose your house.

** [Warning] This is why it is important to read the instructions of a unit and not to alter the intended electrical input - [End of Warning] **

<<>>

This scenario is not possible due to the configuration of plug (caps) that the manufactures install on their equipment. The pin configuration of a 120 volt plug will only fit into a 120 volt receptacle. A 220 volt receptacle has a completely different pin configuration so that no matter how hard you try and push it in, the 120 volt plug will not fit.

Answer 5

A 110 v single phase supply has a peak voltage of 156 volts so a capacitor rated at 230 v can be used. However it must be a bipolar capacitor that works on ac, and not an electrolytic capacitor that works only on dc.

Answer 6

unless it's a wide-input switchmode power supply (almost all phone chargers, etc) it will be destroyed.

if type-plate states: 100-250VAC 50-60Hz, you can use it anywhere in the world.

Answer 7

The 110 appliance will run faster than normal and burn out.

Answer 8

It won't turn on.......