To calculate the minimum fuse rating needed for a 36W bulb on a 12V circuit, divide the wattage by the voltage (36W / 12V = 3A). Therefore, a minimum 3A fuse would be sufficient for a 36W bulb on a 12V circuit.
To determine the fuse size for a 200 watt amp, you will need to divide the power rating by the voltage of the system. If the amp operates on a 12V system, the amperage would be around 16.67A, so a 20A fuse would be appropriate for a 200 watt amp.
Yes, you can use a 250 watt bulb with a 15 amp switch. The switch is rated for up to 15 amps, which is more than enough to handle the power of a 250 watt bulb. Just make sure that the wiring and other components in the circuit can also handle the load.
1 amp
A 15 amp circuit can handle approximately 8-10 60 watt bulbs. Each 60 watt bulb draws 0.5 amps of current, so you divide the circuit's amp rating (15 amps) by the current draw per bulb (0.5 amps) to get the approximate number of bulbs it can handle.
To calculate the minimum fuse rating needed for a 36W bulb on a 12V circuit, divide the wattage by the voltage (36W / 12V = 3A). Therefore, a minimum 3A fuse would be sufficient for a 36W bulb on a 12V circuit.
To determine the fuse size for a 200 watt amp, you will need to divide the power rating by the voltage of the system. If the amp operates on a 12V system, the amperage would be around 16.67A, so a 20A fuse would be appropriate for a 200 watt amp.
Yes I do not see why not as long as the in line fuse does not exceed the power the amp is pulling. You want the fuse to blow instead of the amp so you need a fuse that can only handle 1600 watts or the equivalent to....
Yes it can provided the volotage is right, because for a bulb the volt-amps are equal to the watts - if it is an incandesent bulb. For a fluoresecent bulb the power-factor must be better than 100/150 or 0.67.
The cable voltage is set by the voltage of the supply and not by what is connected to it. But a 100 watt amplifier on a 120 v supply would draw less than 1 amp even at high volume.
That depends on the type of bulb AND on it's power usage. An old incandescent bulb of 100 watts uses about an amp, a 60 watt uses about a half amp. But a florescent bulb putting out the same light would consume about half the current, and a LED bulb would use less than half that.
You don't it is a 100 amp fuse.
Yes, you can use a 250 watt bulb with a 15 amp switch. The switch is rated for up to 15 amps, which is more than enough to handle the power of a 250 watt bulb. Just make sure that the wiring and other components in the circuit can also handle the load.
It will draw over 18 amps and will blow a 15 amp fuse.
Depends on what that fuse protects. Highly unlikely you can drive this car with a 100 amp fuse missing but possible.
.5 amp
1 amp