answersLogoWhite

0


Best Answer

Lighting flicker

User Avatar

Wiki User

10y ago
This answer is:
User Avatar
More answers
User Avatar

AnswerBot

5mo ago

overloading any one circuit and to minimize the impact of a single circuit failure on the other. This separation also allows for better control and distribution of electrical loads, helping to prevent outages. Lastly, it enhances safety by reducing the risk of fire hazards and ensuring that critical systems remain powered in case of an issue with the lighting circuit.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Power and lighting loads are usually on separate feeder circuits to prevent?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences
Related questions

What is the right circuit break to be used for lighting circuits?

Usually 15A or 20A, but it depends on the wire used.


What can prevent a short circuit?

Usually good workmanship goes a very long way to prevent short circuits.


Can you plug a motion detector light into an outlet?

Yes of course, power is power, all 110volt, what ever the source in your house (except a dryer circuit that is usually higher). The difference is the amperage of the circuit. Lighting circuits have amperage controlling breakers that are usually 15amp, power circuits are usually 20amp but excepting a very very unusual condition you would not need to worry about it.


What does a Lighting Director do?

Usually manages the lighting department - including the setup, packup, crewing and overall production of an entertainment lighting installation. They usually have little or no creative involvement in the production - this is usually the job of the lighting designer.


What excatly is pendant lighting?

Pendant lighting is a choice of lighting in which the lighting actually suspends from the ceiling on a wire like fixture and then is usually concealed into a pendant covering.


Minimum acceptable value of power factor FOR LIGHTING and MOTOR CIRCUITS?

Usually for a power factor lower that 90% a service charge will be added to the monthly electrical bill. On power factor correction calculations try to get the power factor up to 95%.


This type of lighting repeatedly starts and breaks?

The type of lighting that repeatedly starts and breaks is commonly called fluorescent lighting. Fluorescent lighting is usually found in office buildings.


Can you wire lighting fictures to receptical circuits?

Yes as long as you stay within your local code. Usually a combination of lights and receptacles cannot exceed ten total. Do not wire any light to a circuit that requires a dedicated circuit, such as a refrigerator, dishwasher, etc.


What type of circuit has little to no resistance and will usually blow a fuse?

there are three types of circuits. Series,parallel,parallel-series. Series circuits usually are involved with dimming lights, and blown fuses.


How is electricity distributed in houses in order to supply power to appliances?

Electricity get distributed in the household through electrical circuits. The circuits distribute voltage to receptacles, light and hard wired appliances. These circuits are fed from breakers that are in the distribution panel. The distribution panel is where the utility company's service supply terminates. The distribution panel is the central location where the household circuits originate.


What is a tuning capacitor?

A capacitor whose capacitance is variable (within some range). They are usually used to adjust resonant circuits or delay circuits.


What types of non-ceiling lighting does Minka have?

Most companies that manufacture lighting fixtures make both ceiling and track lighting fixtures. They usually do vanity lighting too, and you can find them at home improvement stores.