With the car turned off, hold down the RCL button.
While holding down the RCL button use either the AUTO/TONE or TUNE/SEEK button to change the time depending on the model of your radio. The left side will change the hours... the right will change the minutes.
Wiki User
∙ 16y agoScot Thomson
To set the clock on a 1999 Ford Mustang, press and hold the clock button, then use the seek or tune buttons to adjust the hours and minutes. Release the clock button once the correct time is displayed.
Wiki User
∙ 8y agoOn the clock there are two small indented buttons next to the display one is for hours the other for minutes. You will need a pen or the tip of a key to push the buttons
if like mine ....push and hold the clock button until the hour flashes , then turn the volume knob to desired hour, hit the set button again , the minutes should flash , turn volume knob to desired minutes , hit clock button again
Wiki User
∙ 12y agogo to eBay n look for an owners manual, or go to a nearby salvage yard n look through all the wrecked trucks to find an owners manual. that's what i did to get the fuse panel for my boyfriends truck.
Wiki User
∙ 15y agoIf its the factory unit, look at the face of the unit and there should be 2 tiny little buttons (holes) on the front. One has an H (hours) next to it and one has an M (minutes). Use a paper clip or a pen and adjust the time.
Terrence Dozer Brewe...
I had clock reset to correct time in 15 seconds, they knew their stuff .! Thank You Answers.. "DoZer"...
Wiki User
∙ 8y agoWell, if it is like my 2002 Ford Windstar, you press and hold the clock button and use the seek and tune buttons to change the hours and minutes.
Wiki User
∙ 18y agounpluged te batery at 12:00 and conect it again. the clock will start a the rigt time. good luck!!!! ^_^ .
Wiki User
∙ 15y agoturn on ignition press right hand button on speedo for more than 3sec hours will flash press to change release button for 5 secs minutes will flash change minutes
To set the clock on a 1995 Ford Probe, press and hold the "CLK" button on the radio until the time display starts flashing. Use the "TUNE" button to adjust the hours and minutes, then press "CLK" again to save the settings.
To set a Vollmond Atomic Wall Clock, first install the batteries and wait for it to receive a signal from the atomic clock. Once the time is set automatically, you can manually adjust it if necessary using the buttons on the clock. Refer to the user manual for specific instructions for your model.
To set the atomic clock model 86715, start by pressing the "SET" button on the back of the clock. Use the "+" and "-" buttons to adjust the hours, minutes, year, month, and day. Press the "SET" button again to confirm your settings. The clock should then synchronize with the atomic time signal to maintain accuracy.
The first time set on a clock is typically 12:00 AM, which represents midnight.
To set the clock in a Toyota Camry, first press the "Clock" button on the audio system. Use the seek and tune buttons to adjust the hours and minutes, then press "Clock" again to set the time.
There should be no difference The difference between the two are the different set of heads and intake used on the 1999 that was not used on the 1997.
How do you set the timing on a 2300 mustang
If your radio has a "clock" button press and hold it while using the up/down tuner( or volume, i forget) button to set the time.
You can set the clock in your 2003 Ford Escape by holding in the volume button. With the volume button held in the clock display will flash. You can then set the clock by turning the tuning knob.
how do you set clock In 2011 f150
How do youchange the clock on a 2002 zx2 ford escort?
Press clock, type digits then ok
.050 inch spark plug gap - 1986 Ford Mustang 5.0 L ( 302 )
hold clock+seek for Hours hold clock+discs for minutes
how do you set or check the timing on a 99 ford expedition?
no. It's a live-rear axle set-up like the Ford Mustang. The is no Crown Victoria ever built for public consumption with an IRS.
hold clock button and use the seek or other button underneath while holding the clock button