0
What else can I help you with?
What if you don't have a capacitor in a fluorescent fitting?
If you don't have a capacitor in a fluorescent fitting, the light may flicker or fail to start properly, as the capacitor helps to provide the necessary phase shift for the ballast to operate effectively. This can lead to inefficient performance and potential damage to the ballast over time. Additionally, the absence of a capacitor can cause increased wear on the electrical components, resulting in a shorter lifespan for the fluorescent lamp. It's important to replace or include a capacitor to ensure proper functioning and longevity of the lighting system.
Does right hand turn lane yield to oncoming left turn traffic onto a highway on ramp if no yield sign present for right hand turners.?
If you have a red light and left turners have a green light then yes. Otherwise the general rule is those turning left yield to those turning right.
Could anyone tell me a poem about country music that doesn't rhyme?
One of the verses of the song ( Don"t think Twice, it"s all right) by Bob Dylan has to descend to bad grammar to make a rhyme. Seem to recall- and there are different versions- Aint no use turning on the light babe, ( Light, Babe) The Light I never Knowd ( bad grammar) It ain't no use turning on the light babe, I"m on the dark side of the road! bad grammar is sued 9 Knowd) to get the thing to rhyme.
Is there any way to check why check engine light is on a 1995 Jeep Laredo?
Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light.If that does not work an OBD 1 scan tool is required.Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light.If that does not work an OBD 1 scan tool is required.
Your ABS light and brake light came on in your 2003 jeep liberty what does this mean?
It means there is a problem with the Anti-Lock Brake System. Check the fluid level in the Master cylinder. If the fluid level is ok, then take it to a professional for repair. you can also reset it by turning over and on the ingintion swith three times
How can I charge a capacitor using a light bulb?
To charge a capacitor using a light bulb, you can connect the capacitor in series with the light bulb to a power source. When the power is turned on, the light bulb will limit the flow of current, allowing the capacitor to charge gradually. The light bulb acts as a resistor in this circuit, controlling the rate at which the capacitor charges.
How does the current from a charged capacitor light a bulb, and how does the brightness of the bulb change as time goes on?
When a charged capacitor is connected to a light bulb, the current flows from the capacitor through the bulb, causing it to light up. Initially, the bulb may be very bright as the capacitor discharges quickly, but as time goes on, the brightness decreases as the capacitor loses its charge and the current flowing through the bulb decreases.
Why does your Hunter fan light blink?
capacitor?
Can we run the fluorescent light fitting without capacitor?
No, a fluorescent light fitting typically requires a capacitor to function properly. The capacitor helps to regulate the electrical current and improves the efficiency of the light, ensuring stable operation and reducing flickering. Without it, the fluorescent lamp may not start, or it could flicker and have a shorter lifespan.
How light is blinking on roads?
It is blinking by a lamp first turning on, then turning off, then turning on, then turning off...
Camry 98 turning light doesn't work?
Camry 98 turning light doesn't work?
What does it mean by nullify?
Turn on the light, turn off the light. Turning off the light, nullifies the action of turning on the light -- to undo.
Why wont my capacitor shut off?
Well it has 2 light bars and a section where it tells you how much juice it has...and it never goes off. I have a 5 Farad Lanzar Capacitor if that helps.
Why is the capacitor used in tube light?
Starters in tube light uses capacitors to produce a momentary high voltage of 400V due to discharging of capacitor. This momentary high voltage will start the gaseous discharge to priduce light by initial flickering . now,if capacitor is not used , the power supply from the main cannot start the gaseous discharge .
Why condenser used in tube light?
A tube light uses a condenser which is the old term for a capacitor. It functions as a small battery in a circuit.
What happens if the capacitor in fluorescent tube becomes faulty?
There's no effect since the capacitor was already faulty i.e it was like not in the circuit. Install a healthy capacitor because it will improve the power factor of the fluorescent lamp circuit thus reducing energy wasted.
What has happened when a light bulb has burn out?
it simply means that a wire from the light bulb is joined or connected to the charged plates of the capacitor.resulting to discharged of the capacitor.
