Inside the right rear window - it's the wiring molded into it.
The Windstar radio antenna is molded into the right rear window glass
its simple really look on the right rear vent window it looks like a defroster but it is not it is a built in antenna
Never mind, just found it. It's in the right rear vent window.
The radio antenna is a fine wire imbedded in the windshield. If your radio doesn't pull in any stations, but you get static then probably the cable came out of the back of the radio. If you recently got a new windshied it may have not had the antenna. You should be an antenna at an auto parts store and install it on the front fender.
You'll have to reprogram the radio code into the radio. This is done to prevent use of a stolen radio. The code should be in your owners manual or the dealership can get it for you.
Sounds like your radio antenna isn't plugged in properly.
It should be directly underneath the stock radio.
From the 1994 Ford Econoline Owners Guide #8 radio memory, 15 amp fuse. #11 radio and clock, 15 amp fuse. #14 power windows, 20 amp circuit breaker.
The antenna connection, for your 2000 Ford Taurus, is on the back of the radio. The antenna cable goes from the radio to the connection in the windshield.
To connect the radio antenna on a 1993 Ford F-150, the back of the radio needs to be exposed under the dash. Plug the radio antenna wire into the back of the radio and tighten the nut.
Did you disconnect the antenna lead?
Unscrew it.
The antenna location on a 2000 Ford Expedition is going to vary depending on the type of radio installed. If XM Radio is available, the antenna will be a very small square on the back roof of the vehicle. If the radio is normal, the antenna is located on the side of a rear, driver's side window.
Ford mondeo 03 cable route and connection points antenna to radio
when trying to hook up a new stero in a ford windstar van what colors go together
i dont know ask your mummy.
You can switch the traction control system off using the switch to the left of the radio on a 2000 Ford Windstar
* Purchase a compatible radio (aka head-unit)* Purchase the Windstar compatible wiring harness kit ($10 or less)* Remove and unplug current radio* install wiring harness per included instructions* connect wiring connections and antenna lead* insert radio until it clicks.See "Related Questions" below for lots more detailed information
See if the "Related Question" below regarding the radio in a Windstar - expect it to be exactly the same...
Molded into the rear passenger side window glass.See "Related Questions" below for more