In a 2009 matiz you must gently pop out the housing (silver) from above the heating controls all the way up to the dials. It is one piece. Start at the bottom and move gently upwards. When this is done you will see the screws to remove both left and right. There are brackets screwed into the sides of the head unit which you will need to remove also. If you want to replace with a different model the bad news is you will need a new housing and cable adaptor (from halfords for about £12). Its a pain in the backside but can be done. Once you have the new parts, follow your common sense and then gently replace the housing from the top first and then applying equal pressure all the way down until it clicks fully in. Hope this helps, wish I had found an answer before I started! :)
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
Begin by removing the decorative cover from your 2001 Pontiac Bonneville radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
1.5 din
look on top of the radio there is a tray. grab the top of the tray and pull out there are clips that hold it together then just let it hang from the wires you will see the radio on brackets then just remove the 4 bolts from the bracket and pull the radio out dont forget to remove the conncetions on the back. once you remove the radio there are 4 screws on each side of the radio that is holding the radio to the bracket. remove those to remove radio from bracket. dont lose those screws your going to need them to install on new radio. any more questions e-mail emezahth@gmail.com
Well remove the radio and there is a master reset on the radio. But if you just remove the positive terminal from the battery it should reset it. And you don't have to remove the radio to do that
you pull it out
Remove the radio retaining cover. Remove the radio retaining bolts. Remove the wiring harness and the cable antenna from the back of the radio. Reverse the process to install the new radio.
The car model Matiz has been through several rebrandings and owners, initially known as the Daewoo Matiz before coming under the Chevrolet Spark brand.
In the United Kingdom, there are a couple of good options for car buyers in the market for a used Chevrolet Matiz. The most noteworthy are Auto Trader, Car Pages, and Parkers.
remove center bezel and ignition lock cover and remove the 4 screws and unplug connectors and antenna lead in rear of radio
remove and replace
The trim around the radio can be pulled off, it is only held in by a few clips. then all you have to do is unscrew the radio from the mount. There is nothing to it really.
remove timing cover
The Chevrolet 3500 rear radio panels are held in place with retaining clips. There will be a retaining clip on the top and the bottom of each panel. Pry outward on each retaining clip to remove the panel.
remove cover with flat head Carefully! refer to owners manual for removing the dashboard cover that sits atop the main engine cover( the one with the cigarette lighter on it) look up under radio with flashlight. see mounting bracket on the right side with two bolts on it going into radio remove two nuts from the bracket remove two screws on front of radio slide out radio yo
Remove the decorative radio cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness from the back of the radio.
== ==