You have to remove the center dash panel to get access to the bolts, screws.
check either end of the dash when you open the doors the fuse panel doors are the pull type
Remove the cup holder and ashtray assemblies, pull the dash face off (tilt the stearing wheel all the way down). Then remove the bolts that hold the radio in the dash, pull the radio out and unhook all the wires from the back.
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio.-Shocker
remove dash from 62 chevy
Go to chevroletforum.com then clik on Impala and select Sticky: How to: Dash front removal and...........
Just remove the screws and pull out the dash, presto! Your a mechanic now
if you go to www.impalahq.com and find where you take the dash off this will get you in the right direction. i know you have to remove the dash to remove the key switch.
You_want_to_put_a_sony_CD_player_in_your_2000_chevy_impala_and_take_out_the_stock_AM_FM_radio_can_you_do_that
It is not necessary to remove the dash. Only necessary to remove enough of the trim pieces to get the radio out. If you look carefully you will see what needs to be removed.
If all the dash lights are out, it is the switch that is the problem.other wise, you have to remove all the lowre pannels to get at the bolts that hold the dash cluster in.
The flasher is built into the hazard light switch. You have to remove dash and take it out from the rear of the dash panel.
Open the driver door and remove the panel on the end of the dash
Flasher is incorporated with Hazard module. Remove front of dash to replace
The 1996 Chevy Impala dashboard is held in place with six retaining bolts and 12 retaining clips. Remove the retaining bolts and pry outward on the retaining clips. The dashboard will come off in two pieces.
The flasher is built into the hazard light switch. You have to remove dash and take it out from the rear of the dash panel.