Add 2 quarts of Honda 4stroke motor oil then check the level @ dipstick and adjust accordingly. Good luck & don't forget to change the oil filter.
How do you get the axle out to change the boots on the cv joints
Start with five quarts and then check the dipstick. Add a quarter quart at a time til the dipstick reads full. Seems to me that if you have to be told this you should be taking your jeep to the instant oil change place and letting the high school dumbasses do your oil change. Just my opinion of course.......
5 to 9 horsepower about 7 horsepower i felt a big change of horsepower in mine
On 350 rancher it located in the back I took the engine off I was told it could be done with out removing it but it wasn't that hard pulling the engine. you have pull the top end off so you can pull the cam to change chain. any questions email me I just did mine Bob pooleb@ns.sympatico.ca
Well. First you have to suck my fat dïck. Then whatsever the fu*k else to fix your piece of sh*t fourwheeler
How do you change the choke cable on a 2000 Honda Rancher?
were is the oil fiter located at on a 2003 Honda rancher es.
There will be no change, because it is a parallel circuit.
I have a 1999 Grand am se and it dont have a dipstick but it do have a red transmission fluid top on the right side of the 3400 sign that could be unscrewed but it don't have anything on it to check the fluid but you could stick your finger in it to see if its anything in it
how do you change front wheel bearing for 420 rancher
Through the dipstick Through the dipstick
we have a 2000 and we just unscrewed it it took a large Philips screw driver
chemical
This is procedure of easy difficulty to remove and replace. This application has stand-alone oil pressure sensor. The first step is disconnecting its attached wiring harness. The sensor can then be unscrewed with a wrench flat. The replacement new oil pressure sensor can then be screwed in and wiring harness reattached.
Not enough oil was added.
if anybody knows german then i think your screwed
You can change the fluid with a mity vac from the dipstick and replace with SPIII fluid -