On the 2011 Jeep Grand Cherokee with the push button start, just press the engine start button without foot on brake, then press the accelerator pedal 3 times within 5 secs, then press the the engine start button once more. The display will go into accessory mode. then simply push start button again to turn accessory off, then start vehicle normally. The change oil message should now be gone. I did this and it worked first time.
Either reset with a scan tool, or by unhooking the battery.
Where is the fuel reset button on a 2000 jeep Cherokee freedom
scan tool or unhook the battery.
Fix the problem and the light will reset itself after a certain number of drive cycles.
Hit the step button until you see 0km to service the hold down the reset button.
There is no reset for the fuel pump on a Jeep.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/ reset switches.
Either reset with a scan tool, or by unhooking the battery.
Where is the fuel reset button on a 2000 jeep Cherokee freedom
scan tool or unhook the battery.
Jeep does not have reset buttons.
Disconnect the battery
Put the key in the door and then lock and unlock it.
Fix the problem and the light will reset itself after a certain number of drive cycles.
The abs light is reset with a scan tool after repairing the failure that caused the code.
Jeep does not use inertia/reset switches.