0
You must first pull the steering wheel and horn assembly then you will see a lock plate that is spring loaded you must remove the clip that holds this in place once you have removed this in the colum you will see a bolt on the left side located close to the switch remove the bolt and pull the switch out install the new one and do the same steps in reverse to reinstall.
Still curious? Ask our experts.
Chat with our AI personalities
Fran
Coach
ProfessorIf you remove the outer case of the steering collum the you will see a whole on the bottom going into the ignition switch, you must insert a thin rod a little bigger than a paper clip but sturdy enough not to bend. insert the key in the ignition and turn the key as you are pushing on the rod and the switch should slide rite out. to put the new one in, just reverse these directions. i did mine in about 5 minutes.
Take the covers off from behind the steering wheel upper and lower, Take the knee covers off and the backing plate. If you look at where the key goes and follow that cylinder, on the other end you will see the switch, it's attached by two screws, very easy to remove, and has a small harness you need to detach from the wires it connects to. Disconnect your battery!!!!
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
with a sharp chisel , there are two break away bolt that hold it in that you have to get loose with a sharp chisel , first make a slot that a flat blade screw driver will fit into and then use the chisel to loosen the bolt once loose turn with the screw driver the rest of the way.
This is easy if you haven't already figured it out. Remove the 4 screws holding the black dash cover 2 top 2 bottom. Remove the ashtray. Pop the black plastic cover around the shifter. It pops up from the back first (next to the parking break). Then remove the black dash center console cover surrounding the tape player. There are 4 more screws holding the tape player in place. Remove them and buy an adapter for the wiring harness and radio antena and you'll be able to install your CD player of choice. Hope this helps someone.
Add your answer:
Earn +20 pts
To take out the old radio in your 1994 Saturn station wagon to put in a new radio CD player how do you remove the wire without breaking it?
You are supposed to strip the wire.
When did Radio Wolga end?
Radio Wolga ended in 1994.
When was Kube Radio created?
Kube Radio was created in 1994.
When was The Connection - radio program - created?
The Connection - radio program - was created in 1994.
When was United Stations Radio Networks created?
United Stations Radio Networks was created in 1994.
