It sounds as if the battery either went dead or somebody unhooked it from the electrical system. Honda radios have access codes that is supposed to prevent them from being stolen if they are removed from the car. In order to get the access code try the following:
First: Check the owner's manual. If you're lucky, sometimes the dealer or former owner will have written down the code number somewhere in the manual (inside the front cover or on the page that describes the radio operation are favorite places). Also check the interior of the glove compartment - sometimes the dealer will affix a sticker containing the serial number there, too. IF NOT: You will need to retrieve the radio serial number. On SOME radios you can do this by holding down both the number 1 and the number 6 buttons simultaneously as you turn on the radio. If you have one of those radios, the serial number will appear in the tuning window when you turn it on. IF NOT: You will need to loosen the radio and slide it far enough out of the dashboard in order to get the serial number off the plate that is affixed either on the back, or the bottom, of the radio case. When you have gotten the serial number - either call the Honda Customer Service 800 number, or stop by your local Honda dealer and give them the serial number and they should be able to give you the anti-theft security code for your radio. WRITE IT DOWN SOMEWHERE WHERE YOU WON"T FORGET IT! This will happen every time the battery is disconnected or goes dead.
By taking the cable off battery putting back on reset code
Turn the radio off and then while holding down numbers 1 and 6 turn the radio back on. This will display the 10 digit radio serial number 5 digits at a time. Each 5 digit code will flash 3 times alternately. If you do not have your radio code you will want to write these numbers down so that you can contact the dealer and obtain your radio code. After the radio serial code has cycled your radio should now read CODE prompting you for the radio code. Once you enter the 5 digit code the radio should work. Of course your presets have been wiped out so you'll need to reset those.
Switch the radio on and go for a run or a shopping trip. After several minutes the message 'err code' will switch to 'code'. enter the code via the left and right arrows (the numbers will be displayed on the radio) after each correct number display press the '1' on the radio to move to the next number. When all 4 numbers are set it will automatically start the radio.
If your radio is locked and needs to be unlocked, it would require a security code versus a radio code.
My code was 4123 I don't know if this will help you any but I pulled my stereo out and the code was under it. So I wrote it on a piece of paper and taped it under my ash tray.I called the dealer and asked how to get it. Try 3241
Depends on what the error code is.
the radio has message error 6
Code for 2007 hiace
Use the radio preset buttons to enter the code after turning the ignition on.
To fix the radio error code in a 2003 Honda Accord EX, you typically need to reset the radio by entering the correct security code. This code can usually be found in the owner's manual or obtained from a Honda dealership using your vehicle's VIN. Once you have the code, turn on the radio, and when prompted, enter the code using the preset buttons. If the radio remains locked, disconnect the car battery for a few minutes and reconnect it before trying the code again.
Your local dealer has to pull the radio and hook it to a computer to find the code. It cannot be done with the radio in the vehicle.
It is the error you get when you have entered the wrong radio code three times. You need a code to unlock your radio if it has been disconnected from the battery i.e. if it was being stolen from your vehicle. Acura considers this an anti-theft device. It is the error you get when you have entered the wrong radio code three times. You need a code to unlock your radio if it has been disconnected from the battery i.e. if it was being stolen from your vehicle. Acura considers this an anti-theft device.
To enter the radio code for a 2007 VW Golf, first turn on the radio. If it displays "SAFE," press the button marked "TP" or "AS" to access the code entry mode. Use the radio preset buttons (1-4) to input the code digits in the correct order. After entering the full code, the radio should unlock and resume normal operation.
To clear a radio error code E00 on a Honda Civic, start by turning off the ignition and disconnecting the car battery for about 10-15 minutes. This can reset the radio system. After reconnecting the battery, turn the ignition back on and check if the error code has cleared. If the problem persists, consult your owner's manual or a professional mechanic for further assistance.
quite possible if cd is stuck this code will appear
By taking the cable off battery putting back on reset code
how do i get a code for my 2007 honda odyssey 2007 if i have the serial for the radio