0
An electric motor needs 2 primary things for it to run. First, it needs power, second, it needs a ground to complete the electrical circuit. Normally this is controlled by the switch...
In this case the wiring diagram needs to be compared to the physical condition of the wiring. If the on/off switch opens/closes the ground, then there is an alternate ground in the circuit probably due to a broken wire. If the on/off switch opens/closes the power, then there usually would be a short in the on/off switch, and the power is spanning the switch.
.. Goog luck..
Wiki User
∙ 8y ago
Wiki User
∙ 17y agoswitch stuck, or bad connection. relay is weak. wiring connectors dirty results in a bad connection. probably in the switch. best guess. hope it helps. duboff
Add your answer:
Earn +20 pts
What episode does yourichi turn human in front of ichigo?
episode 41
Turn signal is not blinking on 1991 Buick Reatta where to you replace this part?
The turn signal Flasher Relay is located… Front seating area, center, under dash, mounted in front driver side of console.
Why would the left turn signal indicator stop flashing and indicator light remain lit on the dashboard and the exterior lamps stay on?
The front turn signal bulb is blown. This is a feature of all modern cars, so that the operator becomes aware that the bulb is not working.
What fuse do you check for a turn signal on a 1990 Buick Lesabre?
If the signal light fuse is blown all the signal lights front and rear would not work. If you have one signal light out I would first suspect a bad bulb or bad connection.
Which inuyasha episode does sesshmoraru turn into a dog deman in front of rin?
inuyasha the final act episode 17
Windshield wipers wont turn off?
A bad relay switch will cause the windshield wipers to not turn off. Replace the relay switch and the windshield wipers should turn off.
How do you turn on windshield wipers?
Look in the owner's manual.
Why wont my windshield wipers turn off?
There are a few different reasons why your windshield wipers may not turn off. You may for example having an electrical issue within the car.
What causes the windshield wipers not to turnoff unless you turnoff the car?
I have a 2003 Acura TL. When turn on my windshield wipers, I'm not able to turn them off unless I turn off the car. The intermittent also doesn't work on the windshield wiper swith.
How do you turn on headlight wipers in a 1989 Mercedes 300?
Wipers on headlights engage when wiper on windshield engages.
In your 97 wrangler sport your wipers will not turn off is this common and how do you fix it?
Windshield wipers not turning off is not a common problem in the 1997 Jeep Wrangler. Remove the windshield wiper fuse to turn them off.
Car Windshield Wiper Repair?
form_title=Car Windshield Wiper Repair form_header=Improve your visibility during inclement weather with new windshield wipers. If yes, do they leave streaks on your windshield?= Do your windshield wipers turn on?= () Yes () No () Sometimes How long have you had the current wipers?= [] Less than 6 months [] 6-8 months [] 8-10 months [] 10-12 months [] Longer than 12 months Would you like new windshield wipers?= () Yes () No () Not Sure
How do you time windshield wipers?
remove the wipers, turn on wiper switch, turn off switch, reinstall wipers @ bottom position torque nuts enough to secure the arm. turn on switch readjust as needed.
Why won't my windshield wipers turn on?
the windsheild whiper motor is probbly Bad
Is it a law in Louisiana if you use your windshield wipers you must turn your light on?
yes
Why won't the windshield wipers turn off?
If the windshield wipers do not turn off in the vehicle, there could be a short between the battery and the wiper motor. It is also possible that the motor is malfunctioning due to the motor not being properly grounded.
Your wipers on your Saturn will not shut off when engine is running but when you turn car off and turn key in the on with not starting you can turn on and off your wipers?
The windshield wiper switch is broken which is located on the windshield wiper motor. You need to replace the whole motor to fix this.
