NOTE: To prevent glass and/or paint damage, do not pry windshield wiper pivot arm from windshield wiper mounting arm and pivot shaft with metal or sharp tool. 1. Turn ignition switch to the ACC position. Turn turn signal and windshield wiper switch ON. Allow windshield wiper motor to move the windshield wiper mounting arm and pivot shafts three or four cycles, then turn off the turn signal and windshield wiper switch. This will place the windshield wiper mounting arm and pivot shafts in the park position. Turn ignition switch to the OFF position. 2. Remove the windshield wiper pivot arm and windshield wiper blade by first applying downward pressure on the windshield wiper pivot arm head, while holding the windshield wiper pivot arm. Then lift the windshield wiper pivot arm to the highest position and, using finger pressure only, grasp slide latch tab and slide latch out from under the windshield wiper pivot arm head. Remove windshield wiper pivot arm and windshield wiper blade assembly. 3. To remove the windshield wiper blade, insert a screwdriver into the slot provided at top of the windshield wiper blade frame, push down on spring lock and pull the windshield wiper blade from the windshield wiper mounting arm and pivot shaft . 4. Install the windshield wiper blade onto the new replacement windshield wiper pivot arm. See sources and related links below for replacement wiper blade information.
Wiper park switch is bad
Either the fuse is blown or the wiper motor is bad.
If you're asking about changing the wiper blade, then see Sources and Related Links below. If its something else, re-submit question with more detail of what is not working or what is happening.
That thing you mention is the equivalent of a windshield wiper. The circular pane of glass is spun by the motor in the center, slings off the water.
You must remove the arm of the wiper and move it down
depending on year. it could be a number of things. check relays, fuses and motor.
The 2006 Nissan Quest takes a special 14" rear wiper blade which is often difficult to find in stores. See sources and related links below for more information.
It is in the reservoir bottle usually. Y-THINK-Y
The 2000 Nissan windshield wiper fuse is located in the fuse box. The windshield wiper fuse will be in the second column, third from the top.
It is on top of the intake manafold, just under the passenger side windshield wiper.
This is a tet
The windshield wiper relay switch, on your 1999 Cadillac Deville, are located mounted to the firewall in the engine compartment. The relay switch will be next to the windshield wiper motor.
coming up from the back of the engine to the pressure nozzles on your hood look on the bottom of your hood and you will see the lines follow the lines back to your windshield wiper fluid
The wiper relay is underneath the dash on the driver's side. In the same location are the relays for the horn, headlamp, flashers and door locks. They are in cluster of relays.
from a Nissan Dearlership or try a junk yard.
motor is working but wiper blades do not move.