Parallax error. Because there is a gap between the needle and scale, looking from either one side or the other of needle will make a difference in the observed reading. In high-end meters there was a general practice of putting a mirror behind a slot in the meter face. If the observer could not see the reflection of the needle in the mirror then the reflection was being obscured by the needle and the observer was perpendicular to, and therefore looking directly at, the scale.
digital and analog
You can see if the capacitor charges and discharges with an ohmmeter. You can check the value of the capacitor if the multimeter has the facility. With an ESR meter you can establish the value of the capacitor while in circuit.
a digital multimeter uses similar input circuits to those used in an analog multimeter for the various scales, but uses a dual slope integrating analog to digital converter to get a precise digital value of four or five digits to display. this type of analog to digital converter is slow but very precise, also though slow it is more than fast enough for a human to not perceive the slowness.
The main advantage of a digital multimeter over an analog multimeter is their accuracy.AnswerDigital instruments are not necessarily more accurate than analogue instruments (although they often are), but they are far more robust and, usually, far easier to read without error. A digital multimeter has no moving parts and is unaffected by gravity, so they can be used at any angle, whereas analogue instruments needed to be placed on horizontal surfaces and not subjected to vibration.
There is no simple way to test FETs with either analog or digital multimeters. Bipolar transistors can be tested to see if their junctions are OK but they can also have failures that cannot be detected with a multimeter.
The analog multimeter has a wider range.
digital
Analog multimeters use a microammeter with a moving pointer to display readings
digital and analog
analoge
A Multimeter is an electronic instrument, every electronic technician and engineer’s widely used piece of test equipment. A multimeter is mainly used to measure the three basic electrical characteristics of voltage, current, and resistance. There are two types of multimeters: Analog Multimeter: The Analog Multimeter or VOM (Volt-Ohm-Milliammeter) is constructed using a moving coil meter and a pointer to indicate the reading on the scale. Digital Multimeter: We mostly used a multimeter is a digital multimeter (DMM). The DMM performs all functions from AC to DC other than analog. It has two probes positive and negative indicated with black and red color as shown in the figure. there are some best multimeters for HVAC.
A multimeter has many parts. Some of these include the display, the controls, the probes, and the power source. Multimeters can be analog or digital.
The only different is one has a needle, the other digital numbers-same as with analog and digital watches.
The accuracy is the biggest advantage.
The purpose is to buffer the input for monitoring purposes
The main advantage of a digital multimeter over an analog multimeter is their accuracy.AnswerDigital instruments are not necessarily more accurate than analogue instruments (although they often are), but they are far more robust and, usually, far easier to read without error. A digital multimeter has no moving parts and is unaffected by gravity, so they can be used at any angle, whereas analogue instruments needed to be placed on horizontal surfaces and not subjected to vibration.
0 is smallest primary voltage division