Wiki User
∙ 14y agoGO AND BUY I NEW light bulb !
Wiki User
∙ 14y agoIt could be a loose connection, faulty turn signal switch or possibly even bad tail light sockets.
The 4 main things that need to be checked and or replaced before replacing the computer with an ABS system are the pads, the rotors, the calipers, and the shocks. Also make sure to look over the brakes as well before putting in the ABS system.
no it is not i checked
no it doesn't the last time i checked.
In the fuse box located under the driver's side dashboard. That fuse is between circuits for air suspension, dash, lights, and a few accessories. Use a multimeter or lamp to find the blown fuse.
WHAT ARE YOU DUMB REPALCE YOUR LIGHT BULBS STUPID! Not stupid replaced circuit boards checked fuses ran test light . When headlights are on no brake light or taillights and have all new bulbs stupid. Turn headlights off brake lights work, so figure that out smart man
either a blown fuse or bad headlight switch
have you checked the fuse? is the dimmer switch turned down? have they just quit working? Headlights/taillights work? Interior light? Need more info!! What have you checked so far?
You didn't mention if you checked/tested the low beam headlamps or not.
in mark 8's they use a controler to make flashers flash. this module has gone bad
i have a 96 olds achieva and my high beam light was flashing, i checked the headlights and one of my low beam headlights was out. once replaced the flashing stopped.
I would go to the high beam switch next (test not replace)
All Bulbs were replaced. fuses all checked, relay switch new and flasher, Also when the relay switch is in it gets really hot. Any suggestions
The bulbs should be checked on a 1993 Dodge Dakota if the taillights are not working. The plugs on the trailer package should also be checked to make sure that they are working.
About the only thing they have in common is the headlight switch. Have it checked out.
only thing left to check is the light switch
faulty switch