Bad ground, Bad Battery. Or The battery was connected improperly. I.E Reverse Polarity.
To provide electricity for the bulb to light up.
Grounds the fuse box. Connect it back up.
Clip art? If you mean as in the Windows clip art, just go to clip are and type in Fantasia 2000, I guess. xoxo clarrox xoxo
C. Clip Art Index
it operates a battery,mostly a 9 volt battery
Yes you do need a battery because the paper clip is usually used for an alternative for a wire and the paper clip is what the electricity travels through, so yes you do need a battery.
Connect the positive clip of the battery charger to the positive terminal on the battery. Connect the negative clip of the battery charger to the negative terminal on the battery. Select the charge rate you desire either 2,4, or 6 amp. The newer battery chargers will let you know when it is fully charged.
it is to clip paper so that the paper would not be flying around everywhere
yes it is necessary..
You have to pull a plastic clip/lever up until it pops out. That will free your battery. You may have to rock it by pushing down and pulling up to loosen the clip.
Take a Energizer, Duracell, etc. battery (the bigger the bulb the bigger the battery) and a paper clip. Bend up the paper clip to a pretty straight line, and attach one end to the end of the lightbulb. Attach the other end to one end of the battery, and POOF! Light! If the bulb doesn't come on try attaching the paper clip to the other end of the battery. If it STILL doesn't work, get a bigger battery.
To hold the specimen or slide
The function of battery terminals is to connect a load or charger to a cell battery. Battery terminals are necessary and common in a lot of batteries.
It is very easy to replace the battery on a 1994 BMW 318i. The battery can be found in the trunk on the right hand side of the car. All you need to do is to use a screwdriver to take the plastic clip holding the battery in place off. After the clip is removed, take the battery out and then replace with a new one.
Connect the positive clip of the charger onto the positive post of the dead battery. If the battery is located inside of a vehicle, connect the positive charger clip to a grounded surface--like an engine block--on the vehicle.
A cholecystectomy clip is something used during the removal of the gallbladder. This clip clamps off all function while the surgeon is removing the gallbladder.