answersLogoWhite

0


Best Answer



This is the methode I had used to change my remote on my Steelmate twoway pager alarm( 838).It should have a learning code button or pinhole(in this case you have to insert a small pin into the hole) on the main controller unit
This is the procedure
1 )Press learning code button/hole for 10 seconds,this will cancel the current remote.
2) Press the learning button for another 2 seconds,then the lead light will turn on .

3) Press the locking button of the remotes within 10 seconds .
This will programme the new remote.

Please post your results

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you program a steel mate car alarm remote?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you reprogram a auto mate car alarm remote?

how or where can i purchase a new auto mate remote contrl for my 2001 toyota sequoia


Can you use a Gemini All-in-one CL033 remote on a freeview box?

i have the same problem mate but cant find the code


Answers to Math mate 7?

Sorry. WikiAnswers will not give you answers to educational program publications


Can you make hollow steel pipe stronger by filling it with sand or expandable foam that turn it hard?

yes you certainly can mate


What word describes the process by which humans allow certain organism to mate in order to pass along desirable traits?

A breading program.


What is a military plane called a drone?

A male bee whose only function is to mate with the queen bee. It also refers to small planes operated by remote control, used for military purposes.


How do you re-code a remote key control for a UK Toyota 1996 Previa 2.4 P reg after leaving it too long on a battery change?

hi mate i have same model and year remove screw at rear of remote then remove bty before replacing with new one hold remote and press both open and close buttond at same time this resets it then replace bty and screw back on this should work


Can you put nylon strings on a steel string guitar?

A: This can be very unsafe! The design of nylon string guitars is very similar from steel string guitars. To get the best sound from a guitar there is a balance between length and flexibility. Nylon strings are under less tension than steel strings so the top is made thinner and the internal braces are lighter allowing the instrument to vibrate more, giving you better volume. The extra pressure that steel strings put on a nylon guitar can, over time, cause the top to pull up, cause braces to come loose, and even pull the bridge off the guitar! Also, most nylon string guitars do not have internal neck reinforcement (truss rod) like steel string instruments do. This will cause the neck to pull forward causing the distance of the strings from the fret tops to decrease greatly making the instrument difficult to play. The tuning gear rollers on nylon instruments are also different. They are normally made from plastic which will not support the pressure of the steel strings. The shafts may break under the extra pressure. Good answer. But if you have a guitar that you don't care about, the sound is very tinny. Alright mate, enough of that, alright mate alright mate mate.


What is the Romanian word for mate?

The Romanian language equivalent of mate is matematică.For the mate tea, also mate.


Why won't the car alarm turn off when you open doors until you start the engine in a R Vauxhall Vectra?

Well a friend and i had this same problem on a 1992 Jeep Grand Cherokee, and the problem was that when she was unlocking her door on the drivers side, it wouldn't turn the alarm off because the theft deteraint system sensor in the key switch had gone bad, so every time she opened the door the alarm went off. So the solution to her problem and posibly yours was to go to the other side and unlock it on that side and it worked for her and hopefully you. Best of luck to you.Answeri had same prob with my vectra easy cure sit in the car put kes in ignition and tiurn to position 1 then press the buttons on the remote key fob a few times this resets the sensor then everything works fine again ANSWERWWW.VVOC.COMany questions you have about the vectra will be answered on that site mate


How does sponges mate?

they mate


How do emu mate and will emu mate whit human?

emus will not mate with humans they can only mate with their own kind