0
What might be wrong if the burner did not light after the glass valve was open?
Wiki User
∙ 12y ago
The valve may be blocked or the gas cylinder/ supply is empty.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How does adjusting the needle valve on the Bunsen burner affects the flame?
The needle valve or flow valve controls the flow of gas into the Bunsen Burner.
What is the valve between the fuel oil headers and the burner valve?
Root valve.
What is the function of the adjustment valve in a Bunsen burner?
The adjustment valve in a Bunsen burner controls the flow of gas, allowing the user to regulate the flame size and intensity. By turning the valve, the amount of gas entering the burner can be adjusted, resulting in a smaller or larger flame.
What causes a gas hot water pilot lite to go out?
No, that is part of the function of the pilot light. To light the burner and to keep the gas valve open. The thermocouple sits in the flame of the pilot and produces a small electrical current that keep the gas valve open. When the tank cools down, the thermostat opens the valve to the burner so that it can light. When the pilot goes out, it is usually the thermocouple that is bad.
What is the function of the needle valve in the Bunsen burner?
The needle valve controls the flow of gas into the Bunsen burner, regulating the size and intensity of the flame. By adjusting the needle valve, you can increase or decrease the amount of gas entering the burner, which in turn alters the flame's temperature and size.
How do you combine the Bunsen burner to the LP gas cylinder?
There will be a valve at the bottom of the Bunsen burner. Using a rubber tubing connect the valve to the regulator of the LPG cylinder.
Where is the combustion shutoff device on a ge hot water tank?
Not sure what you are asking. The control valve on the front where you set the temperature controls the burner. The thermocouple that sits in the pilot flame let the valve open when heater needs to come on. The temperature sensor is in the tank and is on the back side of the control valve. All of these have their part to play in causing the burner to light and shut off.
How do you control the gas entering in a Bunsen burner?
The gas flow in a Bunsen burner is typically controlled using a valve located on the gas line connected to the burner. By turning the valve, you can increase or decrease the flow of gas entering the burner, which in turn affects the size and intensity of the flame.
How do you fix a furnace main gas valve that is stuck in closed position - Thermostat does not always cause main burner to light?
If your main gas valve is stuck in the closed position, it must be replaced. This condition is the reason your thermostat will not cause the main burners to light.
What tool is used to light a Bunsen burner?
A striker or a match is usually used to light a Bunsen burner. The flame should be ignited at the gas valve while the air hole is open to allow for proper combustion.
Description of Bunsen burner?
A tall cylindrical burner with a flame on top, an oxygen valve and a gas supply tube.
How does adjusting the needle valve on the Bunsen burner affect the flame?
Adjusting the needle valve on the Bunsen burner controls the amount of air mixed with the gas. Opening the valve increases air, resulting in a blue, hotter, more oxygen-rich flame. Closing the valve reduces air, creating a yellow, cooler, more fuel-rich flame.
