0
Can taking amplified mass xxx cause cancer
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Are there side effects for GNC pro performance amp amplified endurance booster?
Yes. It gives you endurance that can make you like Superman.
Why is load cell voltage not amplified by op amp?
qi
My guitar amp is making an annoying whistling sound?
It's probably feedback. When you play a note on your guitar, it's picked up by the pickups and amplified by the amp. If you're too close to the amp, the pickups will pick up the amplified sound and it will get amplified again and again. Try moving farther away from the amp. If that doesn't help, make sure all the electrical connections in your guitar are connected properly (double check the output jack.)
What is a pre out amp jack used for?
This is un-amplified audio, you might send to another amplifier.
What is the difference between an amplifier and an amplified chord?
An amp is what produces the sound, however the amp cord is what carries the sound. Some instruments do not need an amp cord. Stated in another way, an amp (or amplifier) is the device that converts the electrical impulses from an instrument into amplified sound. The electrical impulses from the instrument are carried to the amplifier by an amp cord, or an audio cable. This is usually a shielded, two or three conductor cable with male plugs at either end.
How shall you connect pedal effects to a fender amplifier with send in send out jacks?
The send out of the amp to the in of the effects, the out of the effects to the send in of the amp.
What does it mean to have a wet or dry sounding amp?
Wet means the amp sound has effects, while dry is no effects.
Which line 6 amp has a effects loop?
Line 6 Jam amp
Why isn't your audio receiver sending sound out to your TV from a audio out jack?
Your TV excepts pre-amp only. Your Audio out is Amplified. You blew out the amp chip in your TV as soon as you tryed it. Sorry.
How many effects does a fender bullet 150 DSP amp have?
15 effects
Where does the pedal go in the amp?
Gain effects lie overdrive, compressor etc go between the guitar and amp, time based effect eg flange, chorus go in the effects loop.
How do you connect your speakers and sub to your amp?
You connect speakers and a sub to an amp by placing each wire into the appropriate connector. The connectors on the side of the amp are labelled for front, back, side, and sub depending on the configuration.
