0
seppeku is when a samurai commits suicide after an act of dishoner. this was seen as one last act of honer for the samurai.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
In bleach soul evolution why did you go from hallow to soul?
You Died Seppeku (Suicide) To Be One Again Or Become Shinigami Becuase Wastes 5% SP
How do you get hollow ichigo in bleach lost souls?
To become a hollow in the show you are usually a spirit with regret or unfinished business and you can't move on also the hollows feed off of the spirits roaming which can make you also into a hollow also in the book, a soul has to be hungry, for something.im refering to vol.8
How do you replace the fuel filter located on a 1993 Toyota truck 4 cylinder?
Go to the link for Auto Zone on the right for the instructions. I did this last night and it took me about 3 hours. You will need some 12mm, 14mm, and 17mm wrenches and sockets, and a couple of long extensions for your socket. Disconnect your battery, remove the front passenger tire, and then disconnect your power cable on the starter (12mm nut). Remove the starter (one 14mm bolt on bottom, one 14mm nut on top). You'll probably have to use your extensions to get that top nut off. Then take the banjo nuts off the filter, let it drain a minute, and unbolt it from the engine. Put the new one in, tighten the banjo nuts with a torque wrench to 22lbs, and start reassembling everything. Assembly goes a lot faster than disassembly. Keep in mind that this thing is in the worst possible position, and there is no way for you to reach anything, fit your hand where it needs to go, and is a giant contortion act from beginning to end. I hope the sorry Japanese engineer that came up with this idiotic configuration reads this and commits seppeku, or at least gets some bad fugu. The Haynes manual I have for the 1993 Toyota pickup instructs one to remove the wiring harness from the fuel pump in order to depressurize the fuel pump before changing the filter. I could not seem to detach these wires and am guessing the removal of the battery terminals would be in lieu of this procedure. Still I'm concerned that the fuel lines might have considerable pressure in the lines despite the pump being disconnected from it's power supply.
