Username changes are no longer allowed. You'll have to make a new account in order to change your username.
There is no password for Goodgame Big Farm to hack the 3.9 version. These passwords change on a consistent basis, which means once a hack is discovered it is not long before it no longer works.
"Angry faces"? I dont think you can have a angry face. But im going to guess they probably might be available when you create your sim.(After you create your sim you can no longer change their face). IF YOU WANT ME TO ANSWER YOUR QUESTION EMAIL ME AT DANAGIRL444@GMAIL.COM ~SiMqUeSt~
It all depends. On the speed of your internet, RAM, and how big the file is. The bigger file the longer. The slower internet the longer. The less ram even longer.
they never did
A change can happen when a mechanical advantage increases as it becomes longer and thinner.
You will learn to read and write
A change can happen when a mechanical advantage increases as it becomes longer and thinner.
You will learn to read and write
Try to do by your self.
Yes, the mechanical advantage of a wedge increases with its length and decreases with its thickness. Longer and thinner wedges allow for a greater distance over which a force can be applied to overcome resistance, resulting in a higher mechanical advantage.
The spokes of a wheel are comparable to levers. Longer spokes give more mechanical advantage. Even in a wheel that is solid, and has no spokes, the greater the diameter, the greater the mechanical advantage.
Yes, it is true that longer and thinner wedges typically have a greater mechanical advantage. This is because the longer wedge creates a longer slope, which reduces the amount of force needed to split or lift an object. The thinner wedge allows for more concentrated force at the tip, increasing the effectiveness of the wedge.
Increasing the length and decreasing the thickness of the dart tip would likely increase the mechanical advantage. A longer and thinner tip can result in greater penetration force due to the increased pressure on a smaller surface area, allowing the dart to pierce more effectively through a target.
The longer the ramp, the smaller the mechanical advantage. Mechanical advantage is determined by the ratio of the length of the ramp to its height. As the ramp gets longer, the ratio decreases, resulting in a lower mechanical advantage.
A longer lever would typically have more mechanical advantage than a shorter lever. Mechanical advantage is calculated by dividing the length of the effort arm by the length of the resistance arm; therefore, the longer the effort arm, the greater the mechanical advantage.
A wedge increases the distance over which a force is applied, resulting in a decrease in the amount of force needed to accomplish a task. This is achieved by converting the input force into two forces acting perpendicular to the inclined surfaces of the wedge, thereby increasing the mechanical advantage of the system.