It happens if you download porn movies too much, or are constantly on porn sites!
An error code 80130182 means that no internet service was detected by the PlayStation 3. Go to the page and click on the type of internet connection you have. "Wireless or "Wired" connection for more info on what your problem maybe and how to correct it
This is a problem with the security settings on your wireless connection. To do what you were doing when the error code appeared, change your wireless network security type to WEP, or disable security (not recommended).
This code means that it couldn't access the Wi-Fi access point. Make sure you are close enough to your router, and your connection settings match. Also, try using WEP (instead of WPA) if you aren't already.
You don't have good connection with the router. I have the same problem and I am helpless to... But if you know your pin number set it up manually, and it should work. ;)
That's the error message to say that a Bluetooth connection attempt has failed.
Yes, your percent error can be over 100%. This means that somewhere during your experiment you made a big error.
The Percent error for this problem right here is 3% .
The "bus" is the communication system for the computers on the vehicle. Any computer, wire, or connection can cause that problem.
The error is from the connection you have or got a mistaken connection.
Percent error.
never mind. i went into my router configurations and reset the DHCP protocol settings. for some reason this fixed the problem.
Either replace the NIC card, change the cables, and/or network connection devices to a higher speed.
Check your internet connection, either that or your firewall will not let a connection through from Runescape's Servers.
The difference between low percent error and high percent error is one is low and the other is high
An error code 80130182 means that no internet service was detected by the PlayStation 3. Go to the page and click on the type of internet connection you have. "Wireless or "Wired" connection for more info on what your problem maybe and how to correct it
The error in its area is then 2 percent....
1/100